Electronics Forum | Tue Apr 19 21:23:37 EDT 2022 | kumarb
Hi. On our YV88X (Emerald-X), we use the edge clamp + Push-IN clamp to secure the PCB. The push-in metal part pops up fine but unable to move this piece to the LEFT or RIGHT using the dial inside the machine. The latch inside the machine is rotated '
Electronics Forum | Wed Apr 20 18:06:37 EDT 2022 | kumarb
For future readers - just needed a little bit of lube. Many thanks to Michal & the staff @ Trans-Tec (USA) for their excellent support, as always. Please see attached. For our (dated) machine, the black dial would turn only after hitting the gym
Electronics Forum | Mon Feb 22 15:44:42 EST 2010 | remullis
Just bought a used machine and everything was working fine and now the camera will not initialize. Powered down completely and rebooted, same thing. I powered down again moved camera to center of axis, it moves to the lower right hand corner which I
Electronics Forum | Thu Jul 12 11:39:26 EDT 2007 | rgduval
Stephen, I'm hoping that that was the wording, as it makes the most sense. The Td being what it is would tend to make me think that it's a process consideration, rather than a RoHS consideration. Far as I can figure out, chemically, the material m
Electronics Forum | Wed Sep 04 09:47:41 EDT 2019 | smrsteve
Hello All, I've just bought a Quad 4c pick & place machine. It's so close to actually building boards, but just doesn't quite get there. I was wondering if there's somebody out there with experience of these machines that might be able to help...?
Electronics Forum | Mon Mar 07 18:23:30 EST 2016 | ttheis
Hi everyone, I'm about 90% to running production on my gsm but I'm not able to get the machine to look at fiducial marks and make corrections to the placement. When I run advanced board configuration and seek to the first fiducial the pec camera tra
Electronics Forum | Fri Jul 29 11:31:44 EDT 2022 | jojoled
Hi Guys, I have Juki PnP machine with 2 heads, and for some reason, whatever I do, I can not make the machine to use 2independent feeders for parallel picking up single component reference by both heads from 2 feeders. Example , imagine you have a
Electronics Forum | Tue Aug 02 13:58:23 EDT 2022 | jojoled
Hi Thomas, Seems your machines do what I am looking for. Slight time delay between 2picks is OK,( because the software is not made in multithread way), that is OK.....I just want to have 1x definition of the component in placement data and Component
Electronics Forum | Thu Sep 05 07:14:16 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the suggestions. Sorry I didn't reply yesterday as I'd gone home - I'm in the UK, so I'm guessing there's a time difference. Okay, I found the control to turn off the vacuum verify - it's SHIFT - SWITCH/VERIFY. Makes no di
Electronics Forum | Thu Aug 17 13:55:45 EDT 2023 | markhoch
I think we need more information. Is it moving at all? Does it move to a reference position and then stop before returning to the home position? Have you verified that all sensors are working correctly? Does the machine use stepper motors, motors & e
