Electronics Forum | Thu Jun 01 07:40:23 EDT 2006 | netellink
I have a Suzuki vision machine with 4 heads (SMT-1000VL). This machine is using the camera to inspect the nozzels (4 sets) in the nozzel tray changer every time it is going to change the nozzel(s) in the 4 heads. The problem I have is now the machine
Electronics Forum | Fri May 05 09:31:07 EDT 2006 | finalassy
Yes the nozzels that we use are 99.8 percent iron. Does steel wet better, or do you just know that your works good.
Electronics Forum | Fri Oct 02 11:59:37 EDT 1998 | jon Medernach
| I am experiencing solder paste comtaminatin of nozzels on 0603 size components resulting in missing components. The machine is failing to alarm under these circumstances. Has anybody else experienced this problem & found a solution? | Just a sugge
Electronics Forum | Tue May 02 14:30:07 EDT 2006 | finalassy
We have recently bought two new Pillarhose Jade selective soldering units. We are having a extremley hard time keeping the nozzels wetted while running the machine. I know that the nozzels are 99 percent iron. Has anybody ran into this problem, if
Electronics Forum | Wed May 10 08:34:53 EDT 2006 | russ
i'm thinkin it is you
Electronics Forum | Wed May 10 08:38:07 EDT 2006 | jdengler
I think so too.
Electronics Forum | Tue Jul 29 12:51:40 EDT 2008 | grics
I am having some problems with some of my pcbs at ive solder. We are using an ersa versaflow. It has an automated spot/spray fluxer (Interflux Pacific 2009M) , 1 preheat stage, a leaded pot/nozzel, and finally a lead-free pot/nozzel. Nozzels move, b
Electronics Forum | Tue Jul 29 13:35:48 EDT 2008 | grics
We only use one type of flux for Lead Free. It is an alcohol based no clean flux. Is the wave shape and speed as large a factor in ive soldering as in traditional wave soldering? When you say "decrease the Z" do you mean the nozzel or solder heigh
Electronics Forum | Fri Mar 02 12:46:32 EST 2001 | billschreiber
Hi Dale, Care should be taken when using compressed air to dry a stencil. Just as high-pressure sprays can bend delicate land mass areas between fine-pitch apertures, so can high-pressure air. In addition, OSHA frowns on the use of high-pressuer a
