Electronics Forum | Sun Feb 16 02:39:18 EST 2020 | originoat
panasonic kme nozzle dust filter original part PN 010DC181502
Electronics Forum | Fri Dec 15 11:01:14 EST 2017 | robertorocco
I have one Topaz X FNC machine with this problem. The head 2 FNC not change the nozzle. The head 4-6-8 is ok and change, but head 2 no, when he tries to change the nozzle he gives me an error message. What could be the problem?
Electronics Forum | Thu Nov 08 02:09:05 EST 2018 | vinitverma
If the nozzle gets changed properly but the machine still gives the sensor, then the FNC nozzle detection sensor needs to be adjusted. It is a set of 2 sensors on a plate on the either side of the FNC. If the nozzle is not changed successfully and ge
Electronics Forum | Wed Oct 31 13:50:00 EDT 2018 | xenkok555
Check optical head height sensors.
Electronics Forum | Fri Dec 21 18:44:23 EST 2018 | ramsus
hello I chose to change the wet cleaning paper and dry paper with wet cleaning mode activation but I have a solvent leakage problem (solvent leak alarm) I detected a leak at the level of cleaner. can you get an idea about this problem and can help m
Electronics Forum | Wed May 29 07:41:33 EDT 2024 | tommy_magyar
We use the same component on many different products, never faced a similar issue. However, things I would check are: - stencil thickness (ideally 125um) - additional Z move on the parts around the relay (as suggested by kumarb) - check the packages
Electronics Forum | Mon May 16 12:39:48 EDT 2005 | JB
Agreed with the previous posts: *Make sure there is one empty nozzle changer per head. *Make sure there are no components on the nozzle changers that prvent the nozzle from seating flush with the changer. *make sure all nozzles are fully seated. *Ch
Electronics Forum | Fri May 13 18:10:35 EDT 2005 | pde
Make sure all plugs and nozzles occupy the nozzle banks. There should be only one empty position. Make sure all nozzles are fully seated and the machine has the correct location for all of the nozzles. An indication may be the machine is trying to pl
Electronics Forum | Thu May 19 08:28:08 EDT 2005 | geb
Thanks for everyones help. I have resolved this by filling all but one of the nozzle holders in nozzle changer banks.
Electronics Forum | Mon May 16 11:45:35 EDT 2005 | PWH
Agree with PDE. We have two GSM's and we get this error often. Palm down e-stop when you get this error message. Machine will drop nozzle bank down after doing some segment repairs. Open covers and make sure nozzles are seated in reference to ali