Electronics Forum | Tue May 05 14:57:48 EDT 2020 | greezmky
I will have to check the nozzles to see if they are stuck up, but I don't believe so as I changed them all out a couple weeks ago. I have not went back to the feeder yet because I am not getting vision errors. I was able to see the diodes fly off on
Electronics Forum | Wed Nov 16 05:12:36 EST 2011 | bobpan
A couple of things i would try: 1. Does function 30 give you a nozzle height that is repeatable. The number should be around 200.....+/- 20 or so. 2. I would change the z-rod because the spring could be worn out and when the vacuum turns on....it ca
Electronics Forum | Thu Nov 17 22:30:01 EST 2011 | olddog
Hi again Bob, I'll go by your item numbers: 1. OK, I'll not worry about it. 2. Somehow, it seems to me that it must be doing something or in Run Step Placements there wouldn't be different behavior for Alignment type 0 vs. other settings. I know I'
Electronics Forum | Fri May 17 08:43:46 EDT 2013 | fredcalkins
If you have Flexhead nozzles you need to be careful that whatever solvent you use does not attack the gasket adhesive. I might try a couple of drops of a spray like WD-40 or LPS. Let it soak for a few minutes and blow it out with compressed air. Repe
Electronics Forum | Mon May 20 15:19:50 EDT 2013 | smtventasmex
i been trying to do that with a lot of my customers but they can not clean that well it works for just one time but you have to remember than this parts are platic, and will have some damages, i can sell to you quality nozzles at the best price on th
Electronics Forum | Tue Mar 01 03:25:33 EST 2005 | bing
We are using a GDM with a linear piston pump fitted to dispence adhesive on 0603's. Use Universal part number 43273801 needle with a 42346504 piston. The single needle dimentions are 0.010 ID, 0.028 OD, 0.005 stand off
Electronics Forum | Mon Aug 31 06:26:44 EDT 2015 | piyakorn
Hi At our SMT mounting found battery clip stick in the reel pocket and some dropped under pick&place machine from the nozzle can not pick out the part which got recommendation should change the nozzle type from standard placement to be clip sho
Electronics Forum | Sun Feb 16 02:39:18 EST 2020 | originoat
panasonic kme nozzle dust filter original part PN 010DC181502
Electronics Forum | Tue Apr 05 12:03:39 EDT 2022 | my3sons
Hello, we can offer you a great solution for handling these LED's which I'm betting are sticking to the nozzle after placement correct? We use a special tip material that doesn't stick...our part # 2014-2146 $450.00
Electronics Forum | Tue Sep 20 13:11:48 EDT 2016 | ladmo1
I do have a couple pictures, but they aren't very clear and I am not sure how to post them on this site yet.
