Electronics Forum | Wed Jan 28 08:11:20 EST 2004 | stefwitt
Martin, may I ask what your offer is? Does the pick and place machine vendor provide you with a special nozzle, which would not require the peel off cover. Custom nozzles from the OEM are quite expensive, because they implement engineering and test.
Electronics Forum | Wed Jun 10 01:33:20 EDT 2015 | leeg
Are the leaf springs in good order and set right? If they are then it could be calibration related.
Electronics Forum | Mon May 21 09:00:19 EDT 2012 | mosborne1
Try switching to a polymer nozzle. Your machine manufacturer may sell them on any machine shop can mill you one. Also check to see if your pick and place had a puff off function. Some older machines have a mechanical adjustment on the mac valve used
Electronics Forum | Wed Jul 30 11:11:11 EDT 2003 | Roger
Has anyone changed the PD on this part lately. Sounds like a program (PD) issue. Nozzle size should be .7mm. Narrow view should be selected. Tape leaf cover on feeder should be .7mm. Make sure parts aren't on the camera lens. Good luck!
Electronics Forum | Sat Apr 25 02:46:18 EDT 2009 | smellew
FYI SME offers a replacement Tape leaf detection system which covers the whole range of FUJI CP4-CP7 machines.its also very reasonably priced. It doesn't use Fibre Sensors or mirrors. it only has 1 adjustment which is height via Eccentric screw. even
Electronics Forum | Fri Jun 16 15:50:08 EDT 2006 | Bert van den Berg
PSA - Pressure Sensitive Adhesive? I don't know which type of tape the affected reels of parts use but it is not sticky. Thanks everyone for the comments and suggestions. There were no missing teeth on the plastic take-up reels. I have cleaned an
Electronics Forum | Mon Oct 22 10:54:48 EDT 2007 | mulder0990
What type of feeder storage carts do you use for your feeders? I have many of the Fuji CP-6 racks, but I have found the few Mossman Tebbs racks mor useful and safer for the feeders. I am constantly fixing damaged tape leaf covers from operators not
Electronics Forum | Fri Feb 13 10:13:56 EST 1998 | Simon Washer
Has anyone running the cp4-3 feeders (MC type) in 8 by 4 td flavour seen excessive wear on the aluminum body caused by the tape leaf cover and tape leaf retaining clip?? These are the black anodised aluminum feeders (new type) that we run on all cp4
Electronics Forum | Thu Mar 01 16:39:29 EST 2012 | triadelectronics
Our company is going to attempt to place 0201 components using our Fuji CP4-3 with the upgraded SMD3 vision system. Count On Tools is providing the 0.4 mm nozzles and we are using our 8mmX2mm feeders with the 0.7mm tape leaf (if it works at all we w
Electronics Forum | Thu Mar 14 23:20:05 EST 2002 | alanwilson
Missing and misplaced components could be down to board supports set too high or too low. Check the ZO and make sure the deflection is set ok at various points across the board. Check the other usuals such as sticking nozzles, correct size nozzle for
winsouce.jpg)
