Electronics Forum | Tue Jul 12 10:33:24 EDT 2016 | dontfeedphils
I'd start by checking and reteaching the nozzles (this is automatic, it'll measure the nozzle length and vacuum values for each nozzle). After that double check the value you have entered for the PCB thickness as this will impact where the machine t
Electronics Forum | Fri Oct 30 18:47:19 EST 1998 | phillip hunter
| Does anybody know how to update a different nozzle than the standard one on a Fuji IP3 machine? | | I want to use a 15.8 mm height nozzle, but the limit on height size is 10 mm for IP3.I know, I need to use a special nozzle, so I�m trying with a 1
Electronics Forum | Thu Jan 26 09:13:22 EST 2006 | dougs
i didn't see anything about setting shaft height there, only a procedure for measuring nozzle length. just out of interest, whats the cost difference between a re-tipped nozzle and a new one from fuji? And how much is one of those shaft jigs?
Electronics Forum | Mon Nov 29 16:04:47 EST 2004 | Terrapin Station
They are actually diamond impregnated tips. The tip can be cleaned using a special jig. this will extend the life. these nozzles are from a machine platform dating back to 1997. The RSS can last for 1,000,000 cycles. SA and MA are similiar but requi
Electronics Forum | Fri Feb 02 10:24:50 EST 2007 | FredC
Daxman, Have you eliminated nozzle variation? The difference between a new and used CP6 nozzle can be .15mm. On a CP4 I would think it could be more. On new Cp4 nozzles the difference in effective nozzle length should not be more than .04mm. You can
Electronics Forum | Wed Mar 28 20:35:52 EDT 2007 | darby
Quadalign is very similar to the Samsung. I would think that 4% dump on 1206 or even IC is way over the top. If you are certain that your component data is correct; I suspect that your z-axis centring height may be out of whack and that you are eith
Electronics Forum | Fri Nov 26 05:28:27 EST 2004 | Joe
Hi, Thanks for the info. I have been told that the Panasonic nozzles are diamond tipped and as a consequence are quite costly. Do you know how many placements one of these nozzles would be expected to make? Would the nozzle fail by the tip crackin
Electronics Forum | Mon Aug 27 10:17:25 EDT 2007 | Smartens
We bought a used Siemens (thus we have no factory support just yet...) and have run into a bit of a "catch 22" situation. We got an "General Error :694 Incorrect nozzle length" and in the past this had to do with having a defective nozzle on the sle
Electronics Forum | Wed Dec 17 07:48:20 EST 2008 | muarty
Just trialled some NXT nozzles from SMT Xtra - very impressed by the quality of them, I would guess that their CP nozzles would be of similar standard. Had mixed results whilst using Metro nozzles for CP6 equipment, found lengths varying etc. You co
Electronics Forum | Thu Oct 29 17:43:46 EST 1998 | Guillermo Villegas
Does anybody know how to update a different nozzle than the standard one on a Fuji IP3 machine? I want to use a 15.8 mm height nozzle, but the limit on height size is 10 mm for IP3.I know, I need to use a special nozzle, so I�m trying with a 16.00 m
.gif)
winsouce.jpg)