Electronics Forum | Thu Sep 23 18:56:42 EDT 2010 | slwolbert
Greetings all: I may have a simpler issue going on with this Fuji IP2 machine I'm struggling with. IP2 will boot and zero set, but if production is to be done, during the nozzle check sequence it gives a check nozzle message. This is due to the no
Electronics Forum | Wed Mar 20 15:01:37 EDT 2024 | linux
Reboot usually does the trick, Reason for these fault, (1) Nozzle holder, the grippers are holding the nozzle too tight, stretch the spring slightly, (2) shaft is sticking, removed the head lubricate the shaft.(3) Nest not opening and closed within t
Electronics Forum | Tue Sep 28 08:27:55 EDT 1999 | Earl Moon
| if anyone has used or has one of these bga rework stations please give me your opinion on them. I am planning on using the sytem for not only rework but also low volume prototype production for hand built 1 or 2 qty pcb's, so ease of use is impor
| 1 |
