Electronics Forum | Tue Oct 21 05:28:37 EDT 2014 | rob
Hi Emanuel, Chingyi do quite a wide selection of rubber tipped nozzles http://www.chingyi.com.sg/solutions_smt.php If you are in Europe, then Wilfred @ Europe-SMT knows these machines better than most: http://www.europe-smt.com/ Our personal favo
Electronics Forum | Tue Apr 02 13:43:54 EDT 2013 | ericrr
On one of the products uses a QFP (Quad Flat Package)which is not going on straight, maybe 20 pins per 4 sides. sometimes I have to tweak the alignment before the board goes in the oven, this practice can be a bit of a worry if you over tweak it - pa
Electronics Forum | Sun Sep 15 04:45:22 EDT 2013 | jandon
Cleaning and lubrication requires maintenance training. You can really break something if you don't know what you are doing. For example you can break your expensive rubber nozzles or cameras with inappropriate cleaning. Check: - Piping and joint -
Electronics Forum | Wed Sep 16 10:11:17 EDT 1998 | Ben Salisbury
| Has anyone used Fuji's rubber tip nozzles for the IP3? Are they O-ring type or suction cup? I'm having trouble picking up Ompacs due to the top of the part not consistently being flat. Any actual experience with these $1100 nozzles would be appre
Electronics Forum | Tue Jun 18 11:16:39 EDT 2013 | dontfeedphils
Those are nozzle attaching and removing errors, meaning the machine is having a hard time picking up and leaving nozzles. In the head there should be a rubber o-ring, it often needs to be either cleaned and oiled (Juki has a specific oil, make sure
Electronics Forum | Mon Sep 14 13:17:03 EDT 1998 | Alan Archer
Try contacting Count on Tools in Gainesville GA. They are also an after-market manufacturer of nozzles including Fuji. The gentleman to speak to is Mr. Curt Couch. 800-538-0426. Good Luck. Regards, Alan Archer | Has anyone used Fuji's rubber tip n
Electronics Forum | Thu Feb 01 20:17:56 EST 2007 | daxman
I was doing a PM on our CP4-2 and decided to check the placement height of every nozzle. (we're seeing some skewed components and a lot of dropout under stn. 1) I put a dial guage under the nozzle tip at stn 7, turned placing sol on, and checked ev
Electronics Forum | Wed Sep 16 10:35:45 EDT 1998 | John McMasters
| | Has anyone used Fuji's rubber tip nozzles for the IP3? Are they O-ring type or suction cup? I'm having trouble picking up Ompacs due to the top of the part not consistently being flat. Any actual experience with these $1100 nozzles would be app
Electronics Forum | Fri Oct 03 15:56:04 EDT 2008 | ivanahumpalot
What type of placement machine do you have? How is the machines vision system viewing the part, body x,y only? Do you have the option with the vision system to use just the lead information? Can you use the pin itself for placement from an up look
Electronics Forum | Wed Sep 16 16:03:36 EDT 1998 | Ben Salisbury
| | | Has anyone used Fuji's rubber tip nozzles for the IP3? Are they O-ring type or suction cup? I'm having trouble picking up Ompacs due to the top of the part not consistently being flat. Any actual experience with these $1100 nozzles would be a