Electronics Forum | Wed Aug 04 08:40:37 EDT 2010 | keiths487
I used to wrench on those all the time! I really > should be more help to you but it was a few years > ago... A few more things to check - clean the > line sensors on the back of the machine. Check > to make sure you don't have a feeder that i
Electronics Forum | Wed Dec 20 10:04:07 EST 2017 | junkeymonkey246
Hello there, I work at Redcom Laboratories in Victor NY. I'm a student and new to being a machine repair technician. I'm having some bother with one of our TYCO QUAD QSP-2 machines. I keep getting the errors: "WARNING: Head#2 Nozzle RUNOUT=27.1 mi
Electronics Forum | Wed Dec 20 11:04:01 EST 2017 | junkeymonkey246
Perfect! Thank you bobpan! Shes up and running again.
Electronics Forum | Wed Dec 20 10:44:31 EST 2017 | bobpan
The z-rod bellows on head 2 and head 3 are slightly bent. The machine will show you this error if the runout is over 6.5 mils. This is usually caused by too much z when picking parts out of a vib or tray feeder. The machine will probably run. I ha
Electronics Forum | Fri Jul 22 04:54:50 EDT 2022 | dilogic
Nozzles are the issue - too small nozzle and calibration part will move slightly during rotation, as it's quite big.
Electronics Forum | Mon Feb 04 11:01:44 EST 2013 | bobpan
The way its supposed to work...is....when you do a function 30 the z axis should step down until the nozzle tip is seen in the quad align or laser align. The readout should have a nozzle height but if its the earlier firmware for the machine it might
Electronics Forum | Tue Jul 19 22:30:05 EDT 2022 | ttheis
Update: We moved the vacuum post to the front of the machine at the recommended slot 26 (instead of slot 58 in the back) and changed from 340 to 360F nozzles and the machine was able to complete calibration.
Electronics Forum | Fri Jul 22 16:39:18 EDT 2022 | dilogic
Our calibration nozzles (360's) suffered from rubber disease (all rubber parts on GSM disintegrate into odd sticky molasse after a while), so we thought 340's will do. They did not...
Electronics Forum | Wed Sep 04 13:58:36 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the response. 1. Function 30 gives me a consistent 182-185, even after nozzle changes. I can vary this by changing mod code 15 and I have been advised to aim for 90-110, but it doesn't seem to make any difference so I've go
Electronics Forum | Thu Jul 31 07:28:04 EDT 2008 | leemeyer
This sounds like a Quadalign problem. Upon startup the Quadalign system checks runout of the Z-rod and tries to find the tip of the nozzle. It will keep lowering the Z-rod and looking for the tip until it hits it's limit. Check and see if the Quadali
.gif)
