Electronics Forum | Tue Feb 16 16:57:44 EST 2021 | spoiltforchoice
But that only applies fully if you have the nozzles inline head to match, fast turret heads prefer to hammer a single lane, at least that would be my understanding given I don't have one :(. More active reels = more to track, that may matter to some.
Electronics Forum | Fri May 30 08:24:08 EDT 2008 | cyber_wolf
The nozzles get centered at zero degrees and 180 degrees. I believe the yellow asterisk is the measurement at zero degrees, when it rotates to 180 is when you will get a red X or a green O. (In other words the yellow asterisk is normal) I think you
Electronics Forum | Tue Jul 20 04:16:02 EDT 2004 | Charles Huang
Wondering if there any CP7/F4G programmers out there that can help me out with this one. I'm assuming the setting for max and min nozzle in the "environment" section of the part data would allow me to use either the specified max OR min nozzle in th
Electronics Forum | Fri Feb 14 04:46:39 EST 2020 | tamasmagyar
Hi Nizar, Would you consider having maybe separate nozzles for two separate connectors? If they are different in size, you might have a problem there, since the nozzle you use, is only good for the one you get the nozzle for. After that, I assume yo
Electronics Forum | Mon Aug 02 13:06:10 EDT 2004 | jbabson1
If the CP7 is like the CP643, it defaults to the MAX size unless that nozzle is skipped. Then it would switch to the next smaller nozzle on that head.
Electronics Forum | Sun Feb 16 21:46:45 EST 2020 | nizar
Hi Tommy, I don't have picture right now. Surface where the nozzle grip is different width size. Thanks for the point. As per your previous mention, I will look into the tray cavity setting and nozzle. Many thanks.
Electronics Forum | Wed Feb 12 20:19:05 EST 2020 | nizar
Hi All, I have pick DIMM connector using chuck nozzle. Shape data already refer to physical size. Unfortunately, connector drop during pick up, and have many dislodge. Can we understand what might be the reason ?
Electronics Forum | Mon May 25 20:17:56 EDT 2009 | paligora
Hi , we have problems with the pick & place nozzle when assembling data switches on the PCB. The SMT switches have top surface with diameter of 2.6mm and our supplier is suggesting that if we need to replace the current nozzle which has oval suction
Electronics Forum | Thu Feb 13 04:04:36 EST 2020 | nizar
Hi Tommy, Thanks for the reply. We use chuck nozzle and grip the dimm connector body to pick up. The concern is; we do pick up 2 same connector but different component size (height and width) due to different company. So, we create two different
Electronics Forum | Thu Aug 22 02:18:09 EDT 2002 | mjabure
Specify the nozzle size as 1.4 in both the nozzle allocation table and the PD, the nozzles will still pass center test as the size variation is still within tolerence.