Electronics Forum | Fri Apr 20 21:16:29 EDT 2018 | sarason
And if it is a hard rubber nozzle for a large IC make sure it is still pliable. And solder paste isn't stuck up the end of your nozzle sarason
Electronics Forum | Thu Nov 08 02:09:05 EST 2018 | vinitverma
If the nozzle gets changed properly but the machine still gives the sensor, then the FNC nozzle detection sensor needs to be adjusted. It is a set of 2 sensors on a plate on the either side of the FNC. If the nozzle is not changed successfully and ge
Electronics Forum | Wed Jun 10 00:34:40 EDT 2015 | vinitverma
I understand from your post that the head does go to the nozzle changer intending to change the nozzle but sometimes it entirely fails to pick up the nozzle and sometimes the nozzle gets picked up a bit but gets stuck in the nozzle changer. This mos
Electronics Forum | Tue Feb 15 06:53:50 EST 2005 | cyber_wolf
It seems that every time we do maintenance on our CP6 windmills, we have a lot of problems with nozzles sticking up inside the holders. It seems to happen for a while, then it goes away after we run for a bit. We follow the Fuji maintenance procedure
Electronics Forum | Mon Aug 21 10:47:48 EDT 2006 | FredC
Hello Mika, I just checked a windmill and a test nozzle we have on the bench. The useful travel of the nozzle before the risk of the crosspin getting stuck in the loading gate is 1.5mm, if it gets stuck it is the nozzle is 1.7 up. If the cross pin is
Electronics Forum | Wed Jan 18 12:57:22 EST 2006 | cyber_wolf
Since I have posted on this last, we have found that 99% of our nozzle sticking problems are do to part height problems. I have been told that CP6 machines are very sensitive to part height do to the amount of spring travel in the nozzle. If you hav
Electronics Forum | Tue Nov 11 09:45:44 EST 2008 | slthomas
Is the package too large for the nozzle? They can rotate (or just fly off) after centering if they're not stuck solidly to the nozzle when they're being rotated for orientation.
Electronics Forum | Mon Apr 08 16:41:07 EDT 2013 | rgduval
I need to replace the number 1 head on my CSM84. The nozzle is stuck in the tube, and I haven't been able to get it out. I have, however, done a number on the nozzle while trying :) I have a new head to put in there, but, am being stymied by the r
Electronics Forum | Fri Sep 14 12:32:40 EDT 2007 | sarason
Are you sure there wasn't solder stuck up the nozzle. Which would make for a doggy pressure indication?
Electronics Forum | Sun Mar 10 23:51:47 EST 2002 | mantis
As well as checking board supports you may want to check your nozzles and make sure there not stuck up in the windmill.
