Electronics Forum | Fri Mar 23 07:55:20 EDT 2018 | cyber_wolf
The shafts are not going to origin during zero set. Take a look at your station 12 sensors and fiber units.
Electronics Forum | Sun Mar 12 13:09:33 EST 2000 | Jeff Wilson
Jeff, The problem you are describing MAY be related to the push up pin setting on your component feeder units. Please verify that the push up pin height is set correctly for the feeder units, and the nozzle pick-up and placement heights are to the c
Electronics Forum | Sun Mar 12 13:09:33 EST 2000 | Jeff Wilson
Jeff, The problem you are describing MAY be related to the push up pin setting on your component feeder units. Please verify that the push up pin height is set correctly for the feeder units, and the nozzle pick-up and placement heights are to the c
Electronics Forum | Mon Sep 11 02:31:14 EDT 2017 | sherman
For soldering fume extraction i suggest to you the Weller Zero Smog EL Kit 1. it is very good Fume extraction unit with flexible arm and funnel nozzle also it is portable fume extraction unit, for placement under or next to the bench-top. for more in
Electronics Forum | Wed Dec 06 22:56:50 EST 2000 | Brad Kendall
Steve, Metcal can still provide some of these nozzles. I represent Metcal in Michigan and have a few customers still using the FCR system. They have purchased some new nozzles, but I also have an old demo unit with a large assortment of demo nozzle
Electronics Forum | Wed Dec 06 22:57:23 EST 2000 | Brad Kendall
Steve, Metcal can still provide some of these nozzles. I represent Metcal in Michigan and have a few customers still using the FCR system. They have purchased some new nozzles, but I also have an old demo unit with a large assortment of demo nozzle
Electronics Forum | Thu Jan 28 16:27:05 EST 2010 | Howard
9 micron placement accuracy. Includes Flipper unit, dispenser and double nozzle changer. Any interest? Howard (AIRVAC)
Electronics Forum | Tue Jun 14 17:10:43 EDT 2005 | peter ng
Dear all, I need some information about the Juki 750,760,2010&2020 1)actual vaccum level (with&without nozzle)-after measure 2)blow level(without nozzle)-after measure 3)Is the unit for Juki blow & vaccum level in KPA or mmHg? Thanks!
Electronics Forum | Sat May 29 02:20:08 EDT 2010 | vinitverma
Mch Adjust > Adjust Target > Laser Unit > Nozzle Position. Here the laser will automatically detect the centre of the nozzle. Remember - It'll give you the option of using a component for the test but DON'T use any component. Let it detect the centre
Electronics Forum | Fri Feb 04 11:26:58 EST 2000 | Lisa Anderson
We are currently using an Air-Vac DRS24 hot air BGA/SMD rework unit. Most of our nozzles are designed to channel the exhaust away from nearby components. This and a minimum keepout of .100" has prevented any issues with secondary reflow of those co
winsouce.jpg)
.gif)
