Electronics Forum | Wed Nov 20 10:21:09 EST 2013 | cyber_wolf
Station 17 and 19 errors are almost always caused by dirty clutches or bad sensor dogs. My guess would be bad sensor dogs in this case if it only does it on certain jobs. The reason it happens on those jobs is because there are nozzles being indexed
Electronics Forum | Sun Nov 17 10:50:11 EST 2013 | sara_npi
Hi, I have difficulty on solving unknown nozzle st 17.situation goes like this,almost I run bout 6 models each day,but 1 to 2 models only have this problem.I almost done a few basic troubshoot such as clean censor st 17,clean cluch using prope
Electronics Forum | Tue Nov 19 12:34:33 EST 2013 | jimmyboz
I am not trying to be critical but, you didn't even say Fuji CP-6 problem. There are CP-6, CP-642, and CP-643 machines, are asking 2 model as 642? Anyway, slow the cam speed down in the proper to 40 or 50%. If the problem goes away check the mainte
Electronics Forum | Fri Jul 09 23:45:22 EDT 2010 | dman97
I have a CP642 machine that always gives me a Station 17 or Station 19 nozzle error when the machine selects the 2.5mm 3.7mm or 5.0mm nozzles. It always throws an unknown nozzle station 17 error after all the heads have switched to the above mention
Electronics Forum | Fri Mar 31 10:22:59 EST 2006 | Tech
It could be related but it is kinda hard to tell from just this info. A lot of times if a clutch gets misaligned so bad that the machine has no idea where it is the machine will stop and turn the clutch several times trying to find its home point. It
Electronics Forum | Thu Sep 12 16:17:07 EDT 2002 | soupatech
There seems to be less play in the pocket than with other parts i've loaded. I was assuming the large nozzle would work better but for reasons unknown to me it didn't. I also tried a 1mm and had parts all over the machine (can you say hand place 100+
Electronics Forum | Wed Dec 10 08:33:08 EST 2008 | lkpdsund
Hello! I have a problem with Assembly Expert 7.3.0. During optimization of the assembleon AX5 an error occurs; The program seems to have a problem connecting the machine library with the component library (device.lib). Even though I have defined th
Electronics Forum | Thu Mar 08 03:13:20 EST 2018 | rob
Don't go down that route, Juki cut spares support a few years ago on these. Although bits are available from China, you do not want to be swapping used cards. They are both also dog slow in real life whatever you do to them. Especially a 760. We'r
| 1 |
winsouce.jpg)
