Electronics Forum | Wed Oct 29 10:36:33 EDT 2014 | blainemoran
Looking for a maintenance mode on the NPM-W where I can isolate and fire different components. For example if I suspected a bad motor is there a way to just attempt to fire that. Any advise?
Electronics Forum | Wed Oct 29 18:08:35 EDT 2014 | tombstonesmt
Good afternoon. Not sure if this is available at an engineer level. Perhaps and SD card with field service access is necessary. We have two lines with NPM-W's and the most we've been able to do is actuate vacuum on the heads during flow checks.
Electronics Forum | Fri Jan 04 05:50:37 EST 2019 | bane016
It's nice to see that you've solved the problem...panasonic npm w2 is very powerfull machine but asks everything to be perfect and everything is pure to work well...looking for a clean ventilated room without dust..regular maintenance daily, weekly,
Electronics Forum | Tue Jan 08 16:12:57 EST 2019 | cbeneat
We are using material control, and our auto support pins are from Quik Tool. They integrated there modules into our machines, we're happy with it. Not using auto changeover as far as I know, I stick to the maintenance side. We have a programmer that
Electronics Forum | Thu Mar 28 20:06:53 EDT 2024 | cbeneat
What type head is it? Try changing the internal filters. If it is a low number head, ie: 1-4 on an 8, 1-6 on a 12 or 1-8 on a 16. These can be accessed by pushing the head to the opposite table for removal. Chapter 11, section 11-6 page 11-6.3 in mai
| 1 |
.gif)
