Electronics Forum | Fri Mar 22 14:21:14 EDT 2024 | carl_p
Clean it then?
Electronics Forum | Fri Mar 22 16:25:01 EDT 2024 | carl_p
Faulty flow sensor in that case
Electronics Forum | Fri Mar 22 15:52:58 EDT 2024 | vsuresh
After cleaning also same issue, replaced by new nozzle also same issue,not cleared
Electronics Forum | vsuresh |
Sat Mar 23 05:36:36 EDT 2024
Electronics Forum | Thu Mar 28 19:36:21 EDT 2024 | linux
ensure the nozzle is inserting fulling into the nozzle holder. ensure shaft is lubricated, clean between the magnetics on the shaft. complete nozzle height calibration
Electronics Forum | Fri Jan 04 16:22:55 EST 2019 | cbeneat
Do you have any experience on CM's? 602/402's in particular.
Electronics Forum | Sat Jan 05 04:13:23 EST 2019 | bane016
actually not...only with NPM W2 AND TT2...and with HDP dispenser...CM602 402 is an older generation than NPM but the principle is the same..the program is slightly different...im more than 10yrs in this job..
Electronics Forum | Mon Jan 07 16:18:12 EST 2019 | cbeneat
Been working with CM's since 2006, we've had 2 lines of NPM's for the last 4 years. I like the NPM's, but the CM's have been a work horse. We have gotten our monies worth:)
Electronics Forum | Tue Jan 08 10:16:58 EST 2019 | bane016
Hehe it's nice to hear that you are satisfied with the machine..The only problems with the NPM that we had was filter full for now... Are you using auto changeover,automatic suportpins and material control?