Electronics Forum | Fri Aug 04 11:13:34 EDT 2017 | tombstonesmt
One tip that I found very useful in this application that hasn't been mentioned is auto pick up position teach. Our Panasonic equipment will constantly move the pick up position in regards to the center of the nozzle when scanned. On older Panasonic
Electronics Forum | Sat Feb 11 09:58:20 EST 2012 | cbeneat
I have a question for any Panasonic CM 402/602 users. We run Cree XPE/XPG/XPC LED's on our machines, and have struggled for years with the lights sticking in our nozzles. We have two types, I believe both designed by Cree, one picks the light up by
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
Electronics Forum | Fri May 13 19:48:28 EDT 2022 | cbeneat
Not completely. We end up increasing the blow off/vacuum break air pressure. The only issue with that is if we go too high, and a small part is close to the light it will blow it out of position. So on occasion there is a balancing act we have to do.
| 1 |
