Electronics Forum | Mon Apr 15 16:33:37 EDT 2024 | cyber_wolf
Unskip part npm1 or take npm 1 out pass thru mode
Electronics Forum | Tue Apr 16 20:38:03 EDT 2024 | digitalshovel
when in assign mode, set npm1 as pass. The condition set will make it pass through to npm2
Electronics Forum | vsuresh |
Mon Apr 15 11:48:14 EDT 2024
Electronics Forum | Sat Jan 05 04:13:23 EST 2019 | bane016
actually not...only with NPM W2 AND TT2...and with HDP dispenser...CM602 402 is an older generation than NPM but the principle is the same..the program is slightly different...im more than 10yrs in this job..
Electronics Forum | Mon Jan 07 16:18:12 EST 2019 | cbeneat
Been working with CM's since 2006, we've had 2 lines of NPM's for the last 4 years. I like the NPM's, but the CM's have been a work horse. We have gotten our monies worth:)
Electronics Forum | Wed Oct 29 10:36:33 EDT 2014 | blainemoran
Looking for a maintenance mode on the NPM-W where I can isolate and fire different components. For example if I suspected a bad motor is there a way to just attempt to fire that. Any advise?
Electronics Forum | Wed Oct 29 18:08:35 EDT 2014 | tombstonesmt
Good afternoon. Not sure if this is available at an engineer level. Perhaps and SD card with field service access is necessary. We have two lines with NPM-W's and the most we've been able to do is actuate vacuum on the heads during flow checks.
Electronics Forum | Tue Jan 08 10:16:58 EST 2019 | bane016
Hehe it's nice to hear that you are satisfied with the machine..The only problems with the NPM that we had was filter full for now... Are you using auto changeover,automatic suportpins and material control?
Electronics Forum | Wed May 01 11:47:44 EDT 2024 | linux
Panasonic provide several courses beginners to advance. Not very expensive
Electronics Forum | Fri Jan 04 16:22:55 EST 2019 | cbeneat
Do you have any experience on CM's? 602/402's in particular.
