Electronics Forum | Thu Mar 29 22:51:35 EST 2001 | davef
I'm confused. [Swatts nu, eh?] Are you trying to avoid cleaning yer OA? [if so, don't do it. (but you know that)] I assume use OA with yer SMT then wash and then NC with yer PTH and third processes. Reet? Are you concerned about post-wash OA
Electronics Forum | Wed May 27 11:54:29 EDT 2009 | allwave
Armando, Make sure chip wave is pumping evenly across. These TD machines require a lot of maintenance (deep cleaning)to ensure all the holes on nozzle are open... My two cents, George
Electronics Forum | Fri May 29 02:08:08 EDT 2009 | cobar
Check that you are getting an even spray pattern from the fluxer.Check that the chip wave nozzle is clean and if possible feed the PCB in to the wavesolder unit at 90 � or 180�.