Electronics Forum | Thu Aug 13 16:25:11 EDT 2015 | emeto
Loctite 3609. Just a small dot under the D-Pak and it works 100%.
Electronics Forum | Tue Aug 11 09:48:22 EDT 2015 | samputrah
We have had two jobs that have the same issues with DPAK's sliding off their pads during reflow. We tried to resolve this by placing epoxy on the side of the component to create a "dam". However this is not repeatable enough to be a quality resolutio
Electronics Forum | Tue Aug 11 09:52:53 EDT 2015 | rgduval
I assume that these parts are falling off during second-side reflow? The easy solution, of course, is to not build high-mass components on first-side reflow. If this isn't practical, however, you can try using epoxy/glue under the component. We'
Electronics Forum | Thu Aug 13 14:10:01 EDT 2015 | markhoch
Hi Sam, I have a feeling that what you're trying to communicate is that your DPAK's are skewing off the pad during reflow. This is caused by a thermal "mismatch" where the solder paste on one side of the DPAK becomes molten before the other, then th
Electronics Forum | Wed Nov 20 01:38:53 EST 2019 | ajspec
Hi, i'm facing solder mask peel off but limited to the solder defined pad only(opening area). no peel off on the other area and it happened on electroless nickel immersion gold finishing only. for other finishing is not affected. kindly advise if you
Electronics Forum | Wed Jul 01 04:54:28 EDT 2015 | jvercamm
hi, the last post on pad cratering dates from 2012. We have (likely similar) problems with a RoHS 783 solder ball BGA size 29x29mm^2 (organic package BT), pitch is 1mm and solder ball diam is 0.5mm the field failure is after 12 months, almost exclu
Electronics Forum | Fri Feb 09 07:51:09 EST 2007 | jax
If the attack was unwarranted I apologize. I still stick to my answer. Unless the board shop can get rid of it you have to find a way to deal with it. Etching trace paths into the stencils is inexpensive and works just fine. If you do not have the ti
Electronics Forum | Thu Feb 14 04:38:43 EST 2008 | marjorie
Anyone knows why BGA fell off sometimes from the board? I was running in a single sided only. I encountered a BGA falling off from the pcb pad. The pcb is ENIG and lead free process. The pads had no solder and didn't looks like having a black pad thr
Electronics Forum | Fri Sep 28 09:30:07 EDT 2001 | kmorris
Just had a similar phenomenon 2 days ago. May relate to your issue --- or not. Like you, I did a once over looking for mechanical obstruction & couldn't find any. Ran a thermal profile on the offending PCB & all checked out. Looked in end of oven
Electronics Forum | Thu Feb 14 08:14:12 EST 2008 | davef
Questions are: * Do the BGA pads on the board take solder when you solder them by hand? * What is the temperature on the BGA pads during reflow? * What is the temperature on the other component pads during reflow?
