Electronics Forum | Fri Mar 28 00:13:29 EDT 2014 | jmelson
I was hoping somebody knew how to do this. My method was to place parts at 0 and 180 degree rotation, and adjust head offset until the parts were in the same position at both rotations. Then, I adjusted the M.A. station offset to zero in on correct
Electronics Forum | Fri Mar 13 17:43:16 EDT 2015 | loganting
how helpful is it to use alignment weighting over fiducial offsets ?
Electronics Forum | Tue May 19 14:32:40 EDT 2015 | duchoang
I agree. 100%.If the parts are offset 50% or less on pads, no problem.
Electronics Forum | Fri Mar 20 03:30:55 EDT 2020 | leeg
Have you tried to Zero the x and Y offset and removed the stencil and re-inserted?
Electronics Forum | Mon Aug 02 17:31:20 EDT 2021 | emeto
You did not mention what is different in the results? Is it offset? Is it amount of paste? Paste height?
Electronics Forum | Wed May 03 03:08:48 EDT 2000 | greg
If I have four PCB's in a Panel with four different angle of rotations (0, 90, 180 and 270 degrees). What would be the formula for my Offsets? I am trying to compare our techos method of programming the Chip Mounter as I noticed that he can't have th
Electronics Forum | Thu Nov 01 16:06:54 EST 2001 | Stefan Witte
I disagree on the dirty glass scale offset theory. If you have a dirt spot on the scale, every time the axis comes over the spot it misses counts. After a few movements it will not find the components in the feeder anymore, because the failure adds u
Electronics Forum | Wed Apr 24 11:11:31 EDT 2002 | cnoonan
Sounds like your problem is your camera setting for Head 1 (Gain & Offset), are you rejecting any other parts on that head? Go to (Set) (Propers) (Cameras) (Gain & Offset) you can then zoom in and out to check light contrast. Check the numeric col
Electronics Forum | Wed Jun 09 17:41:40 EDT 2004 | stevecrowley
Does anyone know of a 3rd party that manufactures the Mirae spindle? We have 5 broken nozzle spindles that need replacing. Also in need of renting or borrowing the Head Offset Jig so as when replacing said spindles we can measure the camera to nozzl
Electronics Forum | Mon Oct 27 01:57:12 EDT 2008 | benefon
Hi It appears as if the clincher is not perfectly centered even if it does appear so. You can try to adjust the clincher offset values by entering trial values for the X and Y offsets. Try changing these values in both positive and negative directio
