Electronics Forum | Wed Nov 28 04:11:11 EST 2018 | mnyut
Yes, unfortunately the quality of the software is very bad. It has been shown that the focus is on new features to win new customers and not fall behind the competition instead of improving the quality. The same mistakes are made again and again. The
Electronics Forum | Fri May 24 17:35:59 EDT 2024 | dontfeedphils
A couple questions for everyone: 1) is there an industry spec that calls out v-score depth requirements? If so, what spec is that and what are the values? I've always heard 1/3 of the depth of the PCB on each side, but I'm not sure if that's a rul
Electronics Forum | Thu May 29 17:48:00 EDT 2003 | jonfox
As far as I know, the limitations apply to to the manufacturing components, not the equipment per say. At this point there is no set date for the US at the national level. Basically our government is run by big businesses and their effect on our na
Electronics Forum | Fri Jan 08 15:02:38 EST 1999 | Dave F
| HI! I am a package engineer in Korea. I have some reasons | to desolder excessive solder at the lead of TSOP and TSOJ | after removing them from the board. The way with solder wick is too time-consuming and depends on the operator. | Does anyone
Electronics Forum | Wed May 21 15:47:34 EDT 2003 | JB
We have an HSP 4796, if the feeder mechanism is the same, this may help you a bit. First make sure that the componet definition is right on the component library. Tape or Embossed. Second, the component thickness vs actual thickness. Is the pick u
Electronics Forum | Fri Jul 13 17:00:34 EDT 2007 | jmelson
Oh, sure, on fine-pitch parts you need a microscope or at least a good magnifier. But, OK, you have some kind of contamination. Solder is one thing, but where are these stainless, aluminum and copper particles coming from? Stainless makes me think
Electronics Forum | Tue Jan 25 15:16:35 EST 2000 | Kim Sterling
SMTNETTERS - I apologize in advance if anyone feels this message is too commercial, but we have been receiving inquiries as to APEX's future after 2000, and just wanted to let the industry know that the event will continue. We have the following c
Electronics Forum | Fri Nov 12 10:20:53 EST 1999 | Wolfgang Busko
Now an than I hear, read about the same thing but without mentioning specific frequencies. It�s something that worries me in the back of my mind but not in actual daily workflow. Our boards go up to 50Mhz with digital bus systems and are made with no
Electronics Forum | Wed Jan 09 17:14:48 EST 2002 | mregalia
Do you bond with Al or gold wire? What happens if the Ni is over 150 microinches? Thickness of nickel is one those things that we have not been consistent with. The industry seems to pretty much universally call for 100-200 microinches. Our old board
Electronics Forum | Fri Dec 31 10:22:54 EST 2004 | gpaelmo
I agree that something has to be done with the lead waste but I believe that a recycling program is a better alternative to lead-free. Isn't silver more toxic? How about the venting of alternate alloy fumes, let alone the effects on operators. I say
Reflow ovens for automated SMT PCB assembly, specializing in lead free processing and nitrogen reflow. The best convection reflow ovens on the market.
4 Vreeland Rd.
Florham Park, NJ USA
Phone: 973-377-6800
.png)
