Electronics Forum | Sat Apr 10 10:01:43 EDT 1999 | Jeff Price
| | I am looking for a BGA rework/placement system and would like any experience that you have had. I am looking for a system that is reasonable for the placment, removing and re-balling | | | | thank you | | | -I have had wonderful results with
Electronics Forum | Sun Jan 09 07:10:13 EST 2011 | darlur
Hello, I got a little problem. I didn't use my OK BGA 2000 for a quite long time and I lost the software for it. Does anyone know where can I get it?
Electronics Forum | Wed Jun 09 12:55:04 EDT 1999 | Bryan Warner
Does anyone have thoughts on BGA rework. We now use the OK BGA 3000 and now am considering an Infrared machine. Any thoughts?
Electronics Forum | Wed Jan 19 08:44:05 EST 2000 | Rob Douglass
I would like to hear any feedback (good or bad) about the OK Industries BGA-2000 Series BGA and Fine Pitch Rework System. I was not part of the selection process for this machine and my initial opinion is that this unit may be "under-powered". Loo
Electronics Forum | Wed Jun 09 14:51:08 EDT 1999 | Earl Moon
| Does anyone have thoughts on BGA rework. We now use the OK BGA 3000 and now am considering an Infrared machine. Any thoughts? | I've used Pace, Conceptronic and, now, SRT machines. Bottom side IR is OK. Better thermal balance is achieved with hot
Electronics Forum | Fri Feb 23 15:31:31 EST 2007 | realchunks
Running the BGA first is OK. We run double sided BGA baords all the time without problem.
Electronics Forum | Thu Jun 25 15:07:37 EDT 1998 | Chrys
Anybody using this equipment? Got some pros & cons for me? Thanks in advance.
Electronics Forum | Mon Jun 29 12:58:40 EDT 1998 | Phil Teerink
| Anybody using this equipment? Got some pros & cons for me? | Thanks in advance. Have had one for about six months good results, takes some practice though Call me if you wish to discuss 604-291-2025
Electronics Forum | Sun May 15 12:01:05 EDT 2011 | soscomputer
Did you found it ? and where is the link where i can find tecnical information ? bye
Electronics Forum | Thu May 15 03:14:33 EDT 2003 | Hon Choi
Dear all, Not sure if you have this experience, but we've been seeing shorts on the BGA's from a widely known supplier "i". These shorts can not be found on the X-Ray, and when we remove the BGA, the component is ok. We peeled a few BGA's off, and
.gif)
