Electronics Forum | Fri Feb 15 11:58:55 EST 2008 | rkeck
We are looking at an Omni Flow 5 Oven and do not have much information on it. We do know it has a 3" cabinet vent and a 6" vent near the center on the top. If anyone has knowledge of this oven, and has any suggestions or info, we would appreciate
Electronics Forum | Fri Feb 15 15:55:58 EST 2008 | pjc
This is from the OmniFlo 5 Engineering data sheet: EXHAUST SPECIFICATIONS: STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unload-end: 300 cfm (510 m3/hr) at the 4� (102 mm) stack (minimum req
Electronics Forum | Thu Oct 08 22:32:53 EDT 1998 | E.
*Reply to: ericr@nj.tanon.com Without going into a lengthy explaination {at this time}, has anyone experimented, tested, evaluate, and/or 'perfected' an SMT double-side reflow process. Presently I'm using a Kester R593 OA (water soluble) Sn63/Pb37 -
Electronics Forum | Thu Oct 26 08:59:56 EDT 2000 | Antonio A. Medina
Ok guys, I need help. Here's the deal. We're getting micro solder balls under discreets on the bottomside of the board. Here's my set up... MPM screener w/vacuum plate 6 mil metal screen with 90% circular (rounded) apertures 7 mil (measured) past
Electronics Forum | Sat Oct 10 04:58:18 EDT 1998 | Tony B
| *Reply to: ericr@nj.tanon.com | | Without going into a lengthy explaination {at this time}, has anyone experimented, tested, evaluate, and/or 'perfected' an SMT double-side reflow process. Presently I'm using a Kester R593 OA (water soluble) Sn63/
Electronics Forum | Mon Jun 25 19:36:36 EDT 2007 | bga_kid
If you calculate CFM using the numbers you have provided you are pulling 1396CFM out of the oven. I am not sure what Hellers spec is but I know a Speedline OmniExcel Air machine should be set at 300CFM. I do know for a fact that to much exhaust can s
| 1 |
