Electronics Forum | Wed Dec 08 17:48:18 EST 2010 | katguts69
looking for schematics for electrovert omni 7 reflow oven. manufactured in 1998. help!
Electronics Forum | Thu Dec 09 12:31:39 EST 2010 | travishemen
Mike, I can send you a copy. What is your email address?
Electronics Forum | Mon Sep 28 14:27:08 EDT 2009 | soudomphong
I need help with conveyor speed in Omni Excel 7. It fluctuate, and never have a steady speed. I swapped the speed control card,calibrated, encoder, and I still have the same problem. Any help would be appreciated, thanks.
Electronics Forum | Wed Sep 12 11:01:49 EDT 2007 | leemeyer
We have an Omni 7. We were having problems where blowers wouldn't start. Turned out to be the start capacitors and not the blowers. I replaced all of the caps and haven't had any issues since.
Electronics Forum | Tue Sep 29 07:19:12 EDT 2009 | hussman
Does it ramp up and dowm or do you get a jerk in the conveyor every so often? Jerk in the chain is a sticky link in the chain. Lube may work but if really bad needs replacement.
Electronics Forum | Tue Sep 29 13:03:01 EDT 2009 | soudomphong
Thank you for responding. I called Speedline tech support he think there is a short some where in the motor. I changed the motor out and still have the same problem. The chain is normal, and using automatic lubricating. I will check more into this, a
Electronics Forum | Tue Sep 06 15:18:01 EDT 2011 | tdhiggins
Mike, I can send you a copy. What is your email > address? Travis, I could use a copy of the manual or parts and pieces of it. Could you send me what you have? tdhiggins@spectek.com thanks, Todd Higgins
Electronics Forum | Tue Sep 29 12:07:40 EDT 2009 | swag
The electronics degrade over time and you get troubles like you're having and you need to install a "noise reduction kit". Basically it's a new interface card set and some cables. You might call Speedline and ask tech. support if this is something
Electronics Forum | Wed Oct 07 10:04:07 EDT 2009 | soudomphong
Thank you for responding. I called Speedline tech > support he think there is a short some where in > the motor. I changed the motor out and still have > the same problem. The chain is normal, and using > automatic lubricating. I will check more
Electronics Forum | Sun May 10 07:13:38 EDT 2009 | vtech
Hello I would like to know is my decision correct to purchase the following SMT machines for manufacturing of computer Ram modules and Computer Motherbaord. FUJI XP142E PICK AND PLACE FUJI IP3 PICK AND PLAC ELECTROVERT OMNI 7 REFLOW OVEN Also pleas
| 1 |
