Electronics Forum | Thu Mar 05 16:25:27 EST 1998 | Brian Stumm @ ETS
| I am looking for information on reflow temps for a flex board. There is only one 6 pin IC but the board has a 3M double sided tape. | Is it possible to reflow without damaging the tape. Any suggestions? Do you have a profiler for your reflow oven?
Electronics Forum | Thu Oct 27 19:10:36 EDT 2022 | proceng1
My printer handles 1500mm stencil, so no, 4 ft boards print ok. If you are bending the board for the oven, does that mean your printer and PnP handle the full length?
Electronics Forum | Wed Dec 22 18:09:07 EST 2004 | kmorris
At a previous job I had been taught that when reflow soldering polyimide flex circuits, it was necessary to pre-bake them before reflow soldering to prevent delamination. Our procedures said that there must be a 1hr bake prior to reflow, and the flex
Electronics Forum | Tue Aug 13 20:57:01 EDT 2002 | davef
We don�t use this glue. What does Heraeus say about your condensate? [I'm With the previous poster. Your condensate sounds like goop from NC flux not glue.] How to clean out a 3 meter length of chimney? Depends on your tolerance for pain * Take
Electronics Forum | Wed May 26 17:46:02 EDT 2004 | pjc
Electrovert has hard data on electrical and N2 consumption for the new OmniEXCEL series ovens to compare with preceeding OmniFlo series. Have a look.
Electronics Forum | Mon May 24 12:54:25 EDT 2004 | pjc
Maybe here's an opportunity to get a new oven. Electrovert, BTU and Vitronics offer closed-loop N2 control as an option. This, together with other improvements on oven design can reduce N2 consumption by as much as 40%. Not to mention reductions in e
Electronics Forum | Wed Jun 13 21:33:34 EDT 2001 | davef
Todays crazy idea?! (environmental safe) February 22, 2001 05:33 AM Mattias Andersson [http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&&Message_ID=5343&_#Message5343] Turning things just a bit, our working theory is: burnt flux
Electronics Forum | Fri May 14 08:30:52 EDT 2004 | pjc
For any application- high-mix, low volume to low-mix high-volume: J.O.T. Automation board handling MPM UltraFlex 3000 printer CyberOptics SE300 3D post print inspector 2x Mydata Synergy II w/ Linear Magazines and Agilis feeders CyberOptics Flex
Electronics Forum | Tue Nov 07 06:36:39 EST 2023 | ravikumargv
Dear All. Good day.. We have one Omniexcel dual conveyor reflow and recently we had PC got gone bad and now we replaced new mother board and hard disk, but we don't have the previous PC backup, now we need the software. kindly help us to share the
Electronics Forum | Wed Jul 30 10:59:09 EDT 2008 | edmaya33
try Omni-excel 10 from Electovert ( Speedline Technologies ). Has a dual track option designed for modular mounters such as Fuji NXT,XPF, and Siemens.
