Electronics Forum | Mon Mar 20 09:08:42 EST 2006 | mapell
AR Sounds like dirty chains... couple ways to check... Pull off the drive chain for the conveyor. Place a wrench on the (unload end) drive shaft and spin, if it is a bit tough.. dirty rails. Also look at load end of chains. The chain goes low and w
Electronics Forum | Mon Jan 19 08:37:16 EST 2009 | lkpdsund
Hello all! We possess a speedline electrovert omniflo 7 reflow oven at my site. Last week we examined how the solder profile was affected by fan-speed and by providing the soldering process with compressed air(O2) or nitrogen(N2). We also ran the sa
Electronics Forum | Mon Apr 24 14:04:44 EDT 2006 | pjc
You did not tell us where your boards fit on the thermal mass range. That is key. I've run Pb Free low to medium thermal mass boards with good results on a 5 zone oven (5 top/5 bottom). You should not have a problem running a medium thermal mass boa
Electronics Forum | Tue Apr 05 16:20:49 EDT 2011 | cvoyles
I work with a small EMS shop that has extremely good capability because I created it for an R&D Lab for the U.S. Army. We have at times discussed leasing the equipment/facility to other companies who prefer that to farming out their work to an EMS.
Electronics Forum | Sat Oct 17 10:24:12 EDT 1998 | smd
| | | | | | | It seems like most people want to X-Ray their BGAs. We're going to start doing a lot more of them and need to consider X-ray, too. | | | | | | | Q: Do most people/companies X-ray everyBGA or do they just do SPC? | | | | | | | Q: Can yo
Electronics Forum | Mon Oct 19 14:24:06 EDT 1998 | Justin Medernach
| | | | | | | | It seems like most people want to X-Ray their BGAs. We're going to start doing a lot more of them and need to consider X-ray, too. | | | | | | | | Q: Do most people/companies X-ray everyBGA or do they just do SPC? | | | | | | | | Q:
