Electronics Forum | Wed Sep 25 19:38:39 EDT 2013 | colcircuitos
I need OmniFlo 10 Engineering Data Sheet, manual.
Electronics Forum | Tue Jan 03 11:52:10 EST 2012 | daxman
Hi Everyone, I'm looking for a maintenance manual for an OmniFlo 10 oven. Please let me know if you can help me out. Thanks, Dax
Electronics Forum | Thu Apr 15 08:55:36 EDT 2004 | russ
It could be possible that you have some gears or the clutch is slipping when the oven gets warm.
Electronics Forum | Fri Apr 16 11:34:35 EDT 2004 | pjc
possible problem with mechanical interface with encoder to shaft?
Electronics Forum | Thu Apr 24 16:34:18 EDT 2003 | pjc
OmniFlo 10 Engineering Data Sheet has been sent to your SMTnet mail box. Its a PDF 818Kb.
Electronics Forum | Thu Apr 15 16:37:15 EDT 2004 | wgaffubar
I agree with the loose parts but you can also put a O-scope where the encoder output goes into the computer to see if the signal has a lot of noise. A noisy signal can sometimes fool the input card into thinking the encoder pulses are ok.
Electronics Forum | Fri Apr 26 12:39:05 EDT 2013 | mmjm_1099
First started with having to replace the power supply in the computer. Once we did this now I am getting a "power failure detected" error on the screen as an alarm for the oven program. Anyone have some advice or input on this?
Electronics Forum | Thu Apr 15 23:13:29 EDT 2004 | pyro747
What we are finding that the volts on the Drive motor are dropping when the oven gets hotter. As for the encoder not pick up the drop in speed, I ran the wires for the encoder outside of the oven away from everything, didn't help!!! I swapped PC's
Electronics Forum | Wed Jun 10 01:21:40 EDT 2009 | mikawi
So I got to work today. They asked me to finish removing all the parts for the CBS (center board support). While doing this I removed A Tor Tender tolomatic 1/2 inch gear box from the shaft that widens the rails. It is used to link the front and rear
Electronics Forum | Fri Apr 26 15:00:44 EDT 2013 | leemeyer
This is what the manual says about this message : Power Failure Detected A main power failure occurred and the machine is being powered by the UPS. All heaters are shut off immediately ad the conveyor clears all boards If main power is not restored w
