Electronics Forum | Wed Apr 24 12:54:36 EDT 2013 | smtventasmex
Hi i working now on electrovert omniflow 10 tha deos not control the speed of the conveyor on the sofware, i did change the encoder but this ones continue failing, this fail start because we have a short cut on smemma wire, any one have experience wi
Electronics Forum | Mon Apr 29 01:29:29 EDT 2013 | aemery
If your current problem with the conveyor speed was caused by the SMEMA issue, maybe you have a Board #1 problem. The SMEMA communicates to the computer through Board #1. The input signal from the speed encoder and the output analog voltage to the
Electronics Forum | Mon Feb 28 21:42:27 EST 2022 | emeto
Wow this is 21 years old! Impressive.
Electronics Forum | Fri Mar 04 12:29:04 EST 2022 | stephendo
The Historical Society. 20 years old is antique for technology.
Electronics Forum | Wed Feb 23 14:46:52 EST 2022 | astarotf
Hello everyone! We currently have a 10 zone oven, omniflow 10E, the CPU hard drive is bad and we don't have the installation files! neither the software nor anything. Does anyone know any contact or information related to this oven? I am looking fo
Electronics Forum | Fri Mar 04 10:44:54 EST 2022 | bukas
i got 14 machines from 1994 to 2001, where do I apply for medal? xD
Electronics Forum | Thu Mar 03 20:19:28 EST 2022 | astarotf
If our hard drive had scratches on the data lens, the needle was misaligned and caused the drive damage. The disk cannot be recovered.
Electronics Forum | Wed Mar 02 22:11:30 EST 2022 | travishemen
I have successfully revived a dead hard drive by buying an the exact same model and swapping the circuit board from the new an presumably good hard drive to the drive I'm having trouble with. I have done this twice on hard drives that were between 1
Electronics Forum | Thu Aug 11 10:21:40 EDT 2005 | leonb
HI all, i have 2 omniflow 5 zone reflow ovens would these be suitable for rohs compliance also 2 iemme 760 reflow oven with 4 upper zone and 4 lower zones would these be suitable also any feed back would really help
Electronics Forum | Mon Sep 08 11:01:38 EDT 2003 | X
Contact Electrovert on your questions- Tad Formella, tformell@cooksonelectronics.com , 573-346-3341 ex 132
