Electronics Forum | Mon Apr 29 01:29:29 EDT 2013 | aemery
If your current problem with the conveyor speed was caused by the SMEMA issue, maybe you have a Board #1 problem. The SMEMA communicates to the computer through Board #1. The input signal from the speed encoder and the output analog voltage to the
Electronics Forum | Wed Apr 24 12:54:36 EDT 2013 | smtventasmex
Hi i working now on electrovert omniflow 10 tha deos not control the speed of the conveyor on the sofware, i did change the encoder but this ones continue failing, this fail start because we have a short cut on smemma wire, any one have experience wi
Electronics Forum | Fri Apr 16 10:34:29 EDT 2004 | kauer
A couple of questions for You. How old is this oven? Does it have a history of problems? When I have seen speed variations with our Omniflow 7s it is usualy the encoder but it usually spikes rather hard in one spot. You can see this physically and by
Electronics Forum | Thu Apr 15 01:29:35 EDT 2004 | pyro747
Hello Everyone, I am having a pin chain speed problem. The speed of the chain will slow down after start up of the oven. Example if you set the conveyer to run at 41 in/min, as the oven warms up of conveyer will slow down phycally but won't chan
Electronics Forum | Tue Aug 24 07:09:16 EDT 1999 | Brian
| | This is out of the normal scope of this site but� | | | | I am in search of a Digital Camera for use with documentation instructions. What would be the Minimum Resolution that I should require? I will need details of assemblies such as Compone
| 1 |
