Electronics Forum | Mon Feb 15 17:21:24 EST 2021 | bobym
try to use the attached file
Electronics Forum | Thu Oct 10 09:31:36 EDT 2019 | chrislandafont
Hi Everyone, We've just bought a second hand Omron VT-RNS-pt AOI machine. It appears to work fine but we're struggling to understand how to program it. I have the set of manuals but they are not easy going, and it's going to take me quite a while
Electronics Forum | Mon Mar 15 17:38:40 EDT 2021 | dan_ems
Hello, do you solved? I worked few years with Omron and at the beggining was very hard to understnad but after few time it is OK.
Electronics Forum | Mon Mar 19 12:35:15 EDT 2012 | cuervo
have anyone experience in this AOI ?Im going to buy a AOI and im interested to know about this new PCB Inspection
Electronics Forum | Wed Mar 21 21:35:11 EDT 2012 | aoiguy
I agree with Heg,and can say that I went through this process last year and ended up getting a Yestech FX series with an 8 micron camera. I haven't had any issues that they were unable to assist me with via email. There's a big market for AOI equipme
Electronics Forum | Sat Apr 21 07:05:32 EDT 2012 | doremi
Hello sergio, Probably it is too late to answer to your question, but I can not withstand to say some good words about Omron AOI. I'm located in Europe, 6 years ago our company wanted to make some Japanese manufacturers like Mazda & Toyota our client
Electronics Forum | Thu Oct 10 10:27:24 EDT 2019 | tsvetan
Omron is probably worst choice for AOI unless you have long series. Requires too much debug and there is always compromise between setting sharp criterias and get lot of fake errors or setting lose criterias and get boards with defects to pass OK. Y
Electronics Forum | Fri Oct 11 03:56:39 EDT 2019 | chrislandafont
Hi Tsvetan, Yes, I've heard it's difficult to program but good once it gets going. At the moment, I'm working through the manuals, but can't find a step by step guide, just lots of reference material on how to do things, but not knowing what orde
Electronics Forum | Wed Dec 10 15:45:02 EST 2003 | Carl
If your operation is hi-mix low-volume, consider > taking a look at some of the bench-top units out > there. They are lower cost but can give similar > performance as higher cost in-line systems. Some > of the bench-tops cannot do solder fillet
Electronics Forum | Fri Dec 05 08:30:55 EST 2003 | pjc
If your operation is hi-mix low-volume, consider taking a look at some of the bench-top units out there. They are lower cost but can give similar performance as higher cost in-line systems. Some of the bench-tops cannot do solder fillet inspections t
