Electronics Forum | Tue Jul 25 13:40:04 EDT 2017 | davegoad
I have some CERSOT-23 transistor packages with castellated terminals. The 4th lead (drain castellation) is electrically connected to the top of the device by the castellation. The castellation goes up the ceramic body and contacts the metal package
Electronics Forum | Tue Jul 25 14:30:04 EDT 2017 | emeto
Looks like you have a great wetting of your paste :). Once body has been in contact with molten solder, the package could suffer damages on the body(outside and inside) and on the circuitry inside. It is considered a defect. I have seen that before a
Electronics Forum | Sun Aug 04 13:44:01 EDT 2024 | pradeep14
How to Solder SMT Capacitor on top of the Resistor (0805 package). Is their any method/suggestions to solder this component . Thanks in advance
Electronics Forum | Wed Aug 07 14:29:16 EDT 2024 | proceng1
I'm not sure that you could reliably automate it. So it's probably going to have to be a Hand Assembly operation. Maybe hand applying a drop of glue and hand placing the cap before reflow would secure them together so that someone with an iron could
Electronics Forum | Tue Jul 25 16:59:54 EDT 2017 | spitkis2
Is anyone reworking BGA parts with an rf shield on top of the package? Any problems getting it off the board? I am running into an issue in that the shield comes off but the part remains on the board - not because solder has not reached melting but
Electronics Forum | Fri Jun 04 21:27:16 EDT 2010 | deanm
We have a 4 zone Quad ZCR 531B reflow oven with top side heaters only and a mesh belt. Our boards are 2-6 layer, range in size from 2x2 to 7x15, 0402 to D2PAK. What are the limitations/drawbacks of having top side only heat, especially since about ha
Electronics Forum | Fri Oct 26 07:55:49 EDT 2001 | Kenny
Does anybody know how I work out how heavy a part I can have on the bottom side of the board while reflowing top. Obviously there is a tie between the footprint in the paste and the surface tension of solder paste, but what is it ?
Electronics Forum | Thu Jul 20 13:57:04 EDT 2000 | Boca
I am not answering for Techguy2000, but I am chiming in here, I have the same problem. Our resistor packs are ceramic body with no leads, they have a metalized area reminicent of the old castelation leads of year gone by. The lead pitch is 50 mil
Electronics Forum | Thu Jul 20 12:51:50 EDT 2000 | Tekguy2000
We are currently running boards with resistor paks on the solder side of the board introducing these to the wave solder. We cannot get rid of shorting between the leads. We are using a water soluble acohol based flux. The option of going to selective
Electronics Forum | Tue Nov 27 07:36:29 EST 2007 | shy
solder the part is for SMT component (located at top side and bottom side) and wave solder is for THP (located at top side only).
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
winsouce.jpg)
