Electronics Forum | Tue Nov 10 23:17:39 EST 2009 | vinitverma
Hi Jax, I didn't understand your question very well. I'll try to answer based on whatever I could understand! Most Gerber viewers available in the market - especially free versions, DONOT have the capability to group apertures to build component. T
Electronics Forum | Fri Nov 14 10:38:17 EST 2008 | unisoft
You can use UniSoft ( http://www.unisoft-cim.com ) to solve your problem. They advertise here on SMTnet and are a 22-year-old software company. Their combination ProntoPLACE ( http://www.unisoft-cim.com/pcbplace.htm ) and ProntoGERBER-CONNECTION (
Electronics Forum | Sat Jun 08 13:16:06 EDT 2013 | unisoft
Take a look at the Unisoft software ( http://www.unisoft-cim.com ). For over 25 years this software has in use by Electronics Manufacturer CEM/EMS's and OEM's to automate New Product Introduction (NPI). It's perfect for Electronic Contract Manufact
Electronics Forum | Mon Jun 13 07:56:37 EDT 2022 | spoiltforchoice
This is basic spreadsheet manipulation. Sort your exported BOM from your pick and place machine into the same order as your BOM. Now paste the columns you want to compare from one to into the other. In an empty adjacent column you can now put in a fo
Electronics Forum | Fri Oct 06 06:59:00 EDT 2017 | spoiltforchoice
I agree, in Essemtec's case all they needed to to make that 100% friendlier was let the layout visualiser be able to read and display some gerber data (paste and overlay). Otherwise the offline solution is to hold up a blank board/printout to verify
| 1 |
winsouce.jpg)
