Electronics Forum | Wed Aug 09 14:55:42 EDT 2017 | cbeneat
Trying to show documentation/expert opinion to an operator or 2 why it's important to not let a first piece, that they so diligently built for the next shift to let sit for an hour, why that's not a good idea...other than me telling them so. And tel
Electronics Forum | Thu Jul 17 17:40:13 EDT 2014 | proy
I just got a Vtek TM4400 used, and have manuals for most of it, however the operation/programming manual chapter 3 I have is for the newer Touchscreen interface. My unit is a 2 line backlit LCD with a membrane switch panel, I am looking for the oper
Electronics Forum | Thu Aug 14 22:22:30 EDT 2014 | proy
I just got a Vtek TM4400 used, and have manuals > for most of it, however the operation/programming > manual chapter 3 I have is for the newer > Touchscreen interface. My unit is a 2 line > backlit LCD with a membrane switch panel, I am > looki
Electronics Forum | Thu Aug 22 07:48:30 EDT 2002 | Dave Milk
While separating individual pcbs from a panel, operators have caused delamination of the edge of the board, at the tabs that were cut. How can these boards be repaired? The delamination causes them to fail J-STD-001C 9.2.1.1.d. Also, what would yo
Electronics Forum | Fri Jan 03 15:16:54 EST 2014 | ppminc
If all of the lights are on, on the operator interface panel usually that means the EPCU is defective or not fully seated correctly. If you swapped out the EPCU board from another machine you need to make sure its the same type of machine. If it has
Electronics Forum | Mon Jun 11 17:14:13 EDT 2012 | mmjm_1099
1st Question I am working on ROI for a bare board destacker and wondering if anyone has a general guideline to follow. Example of ROI for bare board destacker I have now as follows: $7500 for destacker, Avg panel input 3365, Time to load in panel 7
Electronics Forum | Wed Feb 02 14:55:34 EST 2005 | JB
We have used small hi temp labes, that are placed on our panels, boards before reflow. Each operator has a roll of labels with an assigned number. 4 operators, label 1, 2, 3 and 4. It worked well for us.
Electronics Forum | Mon Sep 21 04:23:16 EDT 2009 | smtbox
R series Features FCS (Flex Calibration System) highly regarded easy maintenance just got even easier! The optional FCS calibration jig is a simple to use system to re-calibrate placement accuracy. The machine automatically picks and places jig comp
Electronics Forum | Fri Jul 26 12:18:43 EDT 2002 | dougt
I'm told that the Contact Systems machines we have will are set up so that if you put a sticker over the fiducial it will skip that board on the panel. I think the machine might prompt the operator that it can't find the fiducial and the operator te
Electronics Forum | Wed Feb 19 09:15:28 EST 2020 | klofgren
@Evtimov My company only recently got our SMT line operational and are just starting to estimate PCBA time. I just wanted to clarify, it seems that your formula will boil down to the number of panels multiplied by the bottleneck operation. Is there
.gif)
.gif)
