Electronics Forum | Sun Nov 06 13:12:17 EST 2005 | sk
Hello, I use Siemens MS128 & HS180. I need to place a lot of TO-252AA, SOT223, ... components. At the moment I use only mechanical centering but I want to center these components opticaly. There is no problem to center chips and other symetrical com
Electronics Forum | Mon May 08 18:13:59 EDT 2023 | joekirin
Do you have an optical centering phase active for centering? You can have hydra tools setup in the package but if there is no optical centering it wont use the hydra.
Electronics Forum | Thu Oct 16 12:35:03 EDT 2014 | upguy
We have tpsys 1.5.18 on our TP9-UFP. We are attempting to run "Optical Centering Calibration". Following the instructions in the manual, we have centered the cross hairs on the camera frame, loaded a "base" board then the L-19-447 calibration boar
Electronics Forum | Mon Sep 23 14:26:27 EDT 2013 | joekirin
On machines such as MyDatas you have the ability to mechanically center parts rather than optically centering. If your machine is capable of doing mechanical centering that would eliminate the need for the vision analysis. -Joe
Electronics Forum | Tue Sep 15 13:20:02 EDT 1998 | Jim Mitchell
Quad Systems sells the Samsung product with Quad's patented QuadAlign optics system and Quad feeders as opposed to the mechanical centering system available on the product direct from Samsung. Generally, all optical centering is superior to mechanic
Electronics Forum | Mon Jul 10 14:40:41 EDT 2006 | Billy D
Dude - check the centering jaws as well. If they're off a bit it'll do this as well. Is it just mechanically centered parts, or optically centered parts also?
Electronics Forum | Fri Oct 17 09:38:07 EDT 2014 | rgduval
Are you able to turn off mechanical centering? Or can you adjust the settings?
Electronics Forum | Fri Oct 17 12:48:59 EDT 2014 | cyber_wolf
The only reason you would need to run this calibration is if the camera was replaced or the centering camera got whacked which is highly unlikely. If your placements are off, put an offset in the parameter file.
Electronics Forum | Wed Dec 08 12:58:49 EST 2004 | clampron
If it were my money and I had your specifications to achive, I would go Mydata. One platform, chip shooter, optical centering, mechanical centering, electrical verification (that works)smart feeders that work, etc.... I have worked on several platfor
Electronics Forum | Mon Jul 29 13:34:28 EDT 2013 | dontfeedphils
Usually the reason it will fail a part like that when you are using mechanical centering is because the part is usually picked so off center because of the body shape. So when the centering jaws close to push the part to center they give up and fail