Electronics Forum | Thu Jan 24 09:53:56 EST 2002 | davef
You didn�t tell us about your solder, wave temperature profile, or the distribution of the problem. So, let�s assume the solder is near eutectic and the problem is wide spread. Wolfgang makes good points. So, let's talk a different tact. When we
Electronics Forum | Sun Nov 01 23:51:44 EST 2009 | boardhouse
Hi Julie, My opinion is that the top board would not pass IPC, solder mask encroachment on pads. Second board is what we call Orange peel,this can be caused two way's. 1) the solder mask was not tack dried enough prior to imaging which caused artwo
Electronics Forum | Wed Jul 09 04:57:11 EDT 2003 | Matt Kehoe
Our company applies solid solder to surface mount lands. While processing a micro BGA design we had some pads fall off, peel, whatever you might call it, from the surface of the board when touched "GENTLY" with the tip of a blade to remove a small s
1 |