Electronics Forum | Mon Jul 26 10:25:12 EDT 1999 | Boca
| | We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that a
Electronics Forum | Mon Jul 26 14:14:51 EDT 1999 | Steve Gregory
| | | We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | | | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is th
Electronics Forum | Fri May 10 13:52:46 EDT 2002 | pjc
FYI: not all OSP are created equal. I have had expierence, both good and bad w/ OSP boards. To qualify the vendor I would take a bare board and run it thru my oven twice on a reflow profile then flux it with NC flux and run it thru the wave solder fo
Electronics Forum | Wed Jul 17 11:52:54 EDT 2002 | tmarc
Hello all, I have a question about OSP. The solder mask over traces leading to SMT pads, in some instances, does not cover all the way to the pad. Of course the stencil apertures do not include traces. After the SMT and reflow process, there is visib
Electronics Forum | Mon Dec 06 19:30:23 EST 2021 | duchoang
OSP finish is the big issue here. You almost can not get 100% coverage solder on OSP with 1 over 1 aperture stencil. Reconsider solder coverage requirement in this case. Check your peak temp in profile may help a little.
Electronics Forum | Thu Aug 31 21:15:46 EDT 2000 | Dave F
From the SMTnet Library try: http://www.merix.com/resourcecntr/papers/osp.doc http://www.merix.com/resourcecntr/papers/hasl_alt.doc http://www.itm-smt.com/articles.html * "Organic Solderability Preservatives" * "OSPs - Better Living Through Modern Ch
Electronics Forum | Wed Mar 21 14:14:12 EDT 2007 | mmjm_1099
Well we just starting using the OSP finish ourselves. We are using the same application so far and have found no major issues. We do SMT to reflow......
Electronics Forum | Thu Aug 31 18:59:55 EDT 2000 | Brian W.
Our customers use OSP, HASL, immersion tin and immersion gold as board finishes. If I recommend a finish to the customer, it is one of the immersion finishes or OSP. Those finishes have the advantage of a flat surface to deposit paste. HASL has va
Electronics Forum | Thu Jul 17 20:20:21 EDT 2014 | mac5
Hi June, The biggest issue with an OSP finish is as soon as the PCB sees a heat cycle (reflow or wave) the finish will begin to degrade. If you have a single sided SMT assembly with THT components installed downstream it works pretty good. But a dou
Electronics Forum | Fri Dec 12 11:52:59 EST 2003 | Marc Simmel
I have encountered problems with a 90/10 tin-lead plated SMT component wicking all the solder paste off the pads on the substrate. Worst, the defect occurs randomly - adjacent leads may have 'good' joints, though heel fillets are poor. The solder pa
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
3 Road Xintang, Fuhai Street,Fuyong
Shenzhen, 30 China
Phone: 13713862102