Electronics Forum | Wed Mar 31 00:40:22 EST 2004 | darburch
We have recently acquired a dynapace shuttlegate. Yes we bought used and it did not come with a manual. If anybody could let me know where I could get even parts of the manual(functionality, parts list) I would greatly appreciate it, Dynapace wants $
Electronics Forum | Wed Nov 02 12:49:59 EST 2005 | Olas
Thank you for the advice, Mika. My question however was not generated by a practical problem, but rather from the fact that we have to design an equipment which must interface with other conveyors. By now we�ll ignore those two points. Regards, Ola
Electronics Forum | Fri Oct 21 03:39:41 EDT 2005 | fastek
Exactly. Poor Olas is pulling his hair out over an issue that has no business being "standardized". The SMEMA guys with apparently way too much time on their hands couldn't simply stop at the communications protocol and leave it at that....they had t
Electronics Forum | Fri Nov 04 20:25:47 EST 2005 | mika
Always happy to share information. Perhaps other viewers on this thread, can get some ideas of "how to". /Sincerely Ps. There is a so called "standard height" which the conveours/machines from different manufactories must be able to reach; without r
Electronics Forum | Sun Oct 30 06:13:23 EST 2005 | mika
I am sorry for my poor english, but perhaps you will undertsand:-) The important thing is to get the conveyors straight: The front fixed rail must be parallel with the next one and also the heigt. The heihgt of the prior conveyour should be (but not
Electronics Forum | Fri Nov 22 14:35:56 EST 2024 | carl_p
Depends on your software level or age. There is a software option to just change this on the newer stuff. Do you have any older cyber optics kit - you can use the older cal kits for other cyber machines - if you have them of course.
Electronics Forum | Mon Oct 06 18:24:34 EDT 2003 | pjc
what type of belt is it and what material is it? round belt, flat belt, etc... if its from a PCB transport conveyor or other PCB handling system, I recommend you contact the OEM. I have spliced belts before- rubber round belt off old Fuji loader and
Electronics Forum | Mon Mar 20 08:36:30 EST 2006 | jdengler
I've never had this problem on an Omniflo oven, but have seen it on others. It has always turned out to be mechanical. A bearing going bad or FOD in the rails. I would pull the chains and carefully check each link of both chains, all of the bearin
Electronics Forum | Tue Mar 21 07:31:54 EST 2006 | cyber_wolf
We had the exact same problem on our OMNI 10. We found that two of the rails the pin chain rides in were warped. Somehow at one point our PC lost communication with the oven and the heaters went wide open for several minutes...this is what caused th
Electronics Forum | Tue Dec 05 20:55:35 EST 2017 | tristanl
Hi all, We traded our 4c work holder for a transport with another company. Eventing works, except that when I put a board in it does not index. All the other functionality seems ok. The rail width moves, I can eject the board, and it knows it needs
.gif)
