Electronics Forum | Fri Apr 28 02:10:19 EDT 2017 | bukas
i'd say its a ball nut. maybe it came loose or the balls are worn out. also, check timing belt! if resonance is periodical like you say then there is great probability that belt or/and belt pulleys got worn out. i had combination of these on one of m
Electronics Forum | Fri Dec 02 05:06:11 EST 2016 | slavek
Hello, my question would be how often you clean the pot? The second picture with the particles looks for me like burned flux etc. When you took out a large quantity of solder dross, I think that big amount of it was released into system. Clean the
Electronics Forum | Thu Jan 05 14:46:48 EST 2017 | dcarlson
We just got a used Nutek buffer, NTM640SXL, and I cannot figure out how to change the pitch on it. We have another Nutek buffer that I can change no problem, but for some reason, this one isn't changing. Is there anyone out there that can help? Th
Electronics Forum | Sat Dec 16 06:16:14 EST 2017 | sherman
In order to find applicable fume extraction, actually it depends on your application. we would like to ask you to check out: http://widaco.net/ to fine out products that we can provide. Fume extraction units that we provide fall into 2 groups: solde
Electronics Forum | Thu Apr 26 13:16:28 EDT 2018 | bobpan
I am trying to figure out how to teach the position of the tooling so that its aligned to the hole in the worknest. In other words...the carousel is out of position. When i go into machine calibration and i step through it the process freezes at a st
Electronics Forum | Fri Apr 12 18:00:23 EDT 2019 | tey422
That's the most difficult part I am trying to figure it out. I am unable to locate an IQ/OQ/PQ record that I could use as a template. That's why I am looking for if there is a sample one out there, which I can use it as the reference.
Electronics Forum | Fri Oct 18 16:40:32 EDT 2019 | tey422
Whenever you are not sure if a part is good or not. Try to use it on the 2nd machine which uses the same part to test it out. If it "test" part works fine on the 2nd machine then it would be ruled out as not the "root cause". In your case, you can t
Electronics Forum | Mon Dec 09 21:00:39 EST 2019 | sssamw
Did you solve this issue? It doesn't much look like the flux dried out, ti should be across whole board and has much more same defect if flux dried out. Did you have failure ratio data to show the defect location, for example 10% at location A on bo
Electronics Forum | Mon Feb 24 07:18:07 EST 2020 | kylehunter
> If your ovens are 480V you may be able to convert > them back to 240V by changing out the elements? > There are industrial suppliers for oven elements > out there. sarason Yes that is true, our dealer can do that, but due to cost
Electronics Forum | Fri May 22 16:35:21 EDT 2020 | gabriel1blue
Thank you! I think the rotary counter motor went out or the belt broke? The left side is moving fine the right doesn't move at all. If I push the right side very close to origin point some times the machine will complete the process. I'll check that
