Electronics Forum | Sat May 22 22:31:21 EDT 2004 | snehal acharya
hi to all, pls give me the detail chart for mil to mm/cm conversion if any since in SMD line all things we were talk is only in to mil so some time i get confused , for this pls clear my doubt you all genius seating there & pls don't laugh the questi
Electronics Forum | Mon May 24 17:49:58 EDT 2004 | Glenn
I have an alternative way for you guys to clean the chains on your wave solder machine. We currently use Oil Eaters (live bacteria). The bacteria attacks the oil and any other chemical making it easier to clean the chains. The product is environmenta
Electronics Forum | Thu Jun 10 16:21:43 EDT 2004 | Charlie
Guy,s I do not have Red-e-set, but Grid-lok offers a fully automatic system that easily installs onto the printers and P&P. It can be set to your board instantly by pressing one button or triggered by the printer to set for each consecutive PCB. They
Electronics Forum | Wed Jun 09 16:52:16 EDT 2004 | Cary Chang
Dear Mira: I had some assembly operation in Manuas before, You can find out the company name and telephone number in the attached web address. From the telephone list of the Manuas electronics companies which you can call them. some of them you can c
Electronics Forum | Fri Jun 11 11:42:14 EDT 2004 | Claude_Couture
hum, I see no problem for your people supporting any line that can run this speed. If your chip shooters are the dual feeder carriage kind, you must run them in replace mode, when one feeder runs out in one carriage, it parks it and continues running
Electronics Forum | Fri Jun 11 18:01:48 EDT 2004 | davef
Bob: This links to a good discussion on scoring by George Verboven. [It discusses "keepout", but doesn't address your question, because George's "keepout" is not the same as yours]: http://www.tkb-4u.com/articles/other/vscore/vscore.php The infor
Electronics Forum | Mon Jun 14 08:14:01 EDT 2004 | Arvind
For each job we create a standard BOM spreadsheet. Our problem is that for every RFQ we have to get price and availability check for each part even though many parts are used in other BOM and this information exist in other spreadsheets. I was wonder
Electronics Forum | Wed Jun 30 16:44:27 EDT 2004 | Richard
You could also try using a wire mesh out of stainless steel(won't rust). We used these as reflow baskets and for covering parts for a steam cleaner we had for W/S flux. go to http://www.mcmaster.com and type in *Metal and Thermoplastic Cloth and Perf
Electronics Forum | Wed Jun 23 13:03:01 EDT 2004 | russ
I would ditto CAL, we have a jewel box 90 with the 5 axis and we love it. I really like being able to tilt,rotate,and move side to side front to back, Angle viewing under a BGA can be very informative as to the quality of reflow in seeing ball coll
Electronics Forum | Wed Jun 30 10:24:27 EDT 2004 | K
We find keeping the work environment at about 22degC and humidity to about 40-50% is the best way to control the solder balls. Before we took measures we were out of control with solder balls especially in the summer months. We run aqueous solder thr