Electronics Forum | Thu Mar 19 07:57:13 EDT 2020 | leeg
Which model of Dek265 is it?
Electronics Forum | Fri Mar 20 03:30:55 EDT 2020 | leeg
Have you tried to Zero the x and Y offset and removed the stencil and re-inserted?
Electronics Forum | Thu Mar 19 03:07:31 EDT 2020 | weglimir
We have DEK265 and a problem with few projects. Normally it works great, but sometimes we have an issue with Alignment out of range error. Currently we have a project where after fiducials configuration in step mode printer shows an error : Align
Electronics Forum | Wed Mar 25 11:09:08 EDT 2020 | sumote
Have you measured and input the "Distance To Image" setting correctly? If that number is off, you will get that error.
Electronics Forum | Tue Mar 31 09:25:18 EDT 2020 | emeto
If you believe your picture is in the middle and is not skewed, than go to your basics and recheck your fiducial locations and detection. Sometimes these machines recognize something around and give you this error. Try program with isolated pads and
Electronics Forum | Thu Mar 19 15:28:34 EDT 2020 | emeto
You are programing something wrong or your image is not in the center of the stencil. On DEK machines you can move a lot in Y by offseting the image in the program. In X machine can move +_5mm. Now, sometimes there is a way around this as well if yo
Electronics Forum | Fri Mar 20 02:10:03 EDT 2020 | weglimir
Hi Printer is DEK265GS if I remember correctly. It is definitely not a programing problem, I have 15 different screens which I've checked and all are working fine. It is also not a problem with Y shift, as I've compensated it with CUSTOM SCREEN o
Electronics Forum | Tue Feb 28 07:31:40 EST 2012 | bk
I'm assuming it's your x wagon tranducers that are out of synch. So the first place to start is look at your couplings on both x motors and make sure one of them isn't broken or starting to break. After that i would try swapping out your x board with
Electronics Forum | Tue Feb 28 08:19:03 EST 2012 | cyber_wolf
Replace both of the big X-wagon ribbon cables to start with. You always have to rule those out before looking at anything else.
Electronics Forum | Wed Sep 23 04:15:44 EDT 2020 | pkmkabigon
Hi all, I have a concern about how to prevent the component from bouncing out of the carrier (embossed pocket). I don't know what the reasons for this problem. Can anyone help me explain and show me the solutions to fix. Tks