Electronics Forum | Tue Aug 11 16:18:41 EDT 2009 | dyoungquist
Oberon (oberonlube.com) makes a high temperature chain lube (oil). When our Heller oven was installed, we were told to use this as the replacement when our original volume of chain oil ran out. I do not know the price for it.
Electronics Forum | Tue Aug 11 08:19:48 EDT 2009 | cyber_wolf
Has anyone located an alternate source for the Fuchs Stabylan oil that Vitronics calls for ? $65 a pint seems a little stiff.
Electronics Forum | Fri Sep 05 12:15:05 EDT 2008 | cyber_wolf
We have 5 ovens that we use this oil on. Its like $23.00 per pint from the manufacturer. But they say you have to buy a case of 24. I just went ahead and bought it from Vitronics.
Electronics Forum | Fri Sep 05 11:32:31 EDT 2008 | realchunks
I just bought some of XPM3 series. according to Vitronics, you shouldn't go through more than two quarts a year per each oven. Have you experienced this? If not then I too would be interested in a 2nd source.
Electronics Forum | Fri Sep 05 10:39:33 EDT 2008 | cyber_wolf
Does anyone know of a secondary source for the 773 ND edge chain lube ? $63.00 a pint from Vitronics is pretty intense.
Electronics Forum | Sat Jul 23 02:16:52 EDT 2022 | poly
Is there are reason for going for larger (or smaller) boards when designing panels for use with a chain conveyor oven? My panels range from 0.6mm 2 layer (for touch with hatched ground) to 1.6mm 4 layer. I'm planning to go for smaller panels to reduc
Electronics Forum | Mon Jul 25 19:12:17 EDT 2022 | proceng1
I generally do not design an array larger than 10" x 12". Other than just thermal mass, the one issue to watch with extra length is if the array is so large that it spans multiple heat zones at the same time. We have panels that are up to 48" l
Electronics Forum | Tue Jul 26 13:34:18 EDT 2022 | emeto
10x6 to 12x8 is ideal for most equipment. Too small panel is not good too for handling by humans and machines. 1.6mm you can use as and depanel on the router. 0.6mm you might need to run on SMT carrier, if you see warping.
Electronics Forum | Sat Feb 15 10:25:50 EST 2014 | jdengler
Can the oven do 400C? If so do them in the oven. Jerry
Electronics Forum | Thu Feb 13 08:08:41 EST 2014 | cyber_wolf
The manual says to bake the edge chains at 400C to clean them. Is anybody doing this ? I need to take my edge chains to a heat treat facility to clean them ? I don't want to spray oven cleaner on them as they appear to be plated with nickel or so
