Electronics Forum | Thu Dec 13 20:52:21 EST 2012 | davef
reflow FROM => products & services
Electronics Forum | Tue Oct 09 20:30:25 EDT 2001 | djarvis
Thank you all for your input. We didn't get the oven and if we did I decided in the short term to just turn it around and run it as a belt mesh oven - the next line we buy runs it's conveyor to suit the oven. Hi to you Marc, it's been a few years. Yo
Electronics Forum | Thu Sep 29 19:45:23 EDT 2011 | edwaterfall01
The conveyor is programmed to turn off the belts and go into an error condition after 30 seconds if the board has not passed the output sensor on the conveyor. The intent is to indicate a board jam and prevent damage to the board or belts. On convey
Electronics Forum | Mon Jan 15 13:49:09 EST 2007 | leemeyer
Hello all, I am having some trouble with the conveyor speed on an Omniflow 7 reflow oven. Recent profiling showed that the conveyor was running to slow so I calibrated the speed using the instructions in the manual. After calibration there was no ch
Electronics Forum | Mon Mar 20 06:21:42 EST 2006 | AR
Have a problem with Omniflo 5 (-97 vintage) pin chain conveyor. Occasionally the conveyor stops for a second or two, then makes a slight jerk, then stops again, makes a jerk etc. Then suddenly the problem goes away only to return next day (we switch
Electronics Forum | Mon Mar 20 08:36:30 EST 2006 | jdengler
I've never had this problem on an Omniflo oven, but have seen it on others. It has always turned out to be mechanical. A bearing going bad or FOD in the rails. I would pull the chains and carefully check each link of both chains, all of the bearin
Electronics Forum | Tue Mar 21 07:31:54 EST 2006 | cyber_wolf
We had the exact same problem on our OMNI 10. We found that two of the rails the pin chain rides in were warped. Somehow at one point our PC lost communication with the oven and the heaters went wide open for several minutes...this is what caused th
Electronics Forum | Mon Jan 15 16:14:15 EST 2007 | leemeyer
This is a used oven, new to us. No product has been setup on it yet. We were establishing som baseline profiles and noticed that the actual profile read didn't even come close to our optimal profile. Further investigation proved that the belt was to
Electronics Forum | Tue Oct 09 11:50:44 EDT 2001 | Marc Peo
Hello Darby! Mike is correct in saying that reversing the conveyor can be done but the position of the cooling zone would be troublesome. I am guessing that you are looking at a left to right machine that you would like to run right to left or vice
Electronics Forum | Wed Jul 15 03:17:47 EDT 2020 | wellmanrau
We have been producing the SMT machines and intelligent equipment for many years, integrated Design, R&D, Production, Sales and Technical Service. What products we manufactured are: SMT Printer/Stencil Printer/Solder Paste Printer, Pick and Place Mac
.gif)
