Electronics Forum | Tue Feb 12 11:26:31 EST 2019 | aldrich17
Does anyone have any info. on an "E869" error code on a Phillips Topaz X SMT machine. Error screen shows "Nozzle down limit sensor is off in A-table YV100X:N2323 YV100XT:n2223 Please check sensor and remove to the cause of this sensor being off.
Electronics Forum | Wed Nov 16 09:33:39 EST 2005 | SuMoTe
I can't help you with most of that, but heres a starting point. "L013: 2nd limit over" means that one of your axis is showing outside operating boundries, as in placement head is too far forward. Make sure all your devices are not pushed out to thie
Electronics Forum | Mon May 18 10:41:46 EDT 2015 | leeg
Over Current is normally when something is jammed.
Electronics Forum | Tue Jun 09 04:48:13 EDT 2015 | vinitverma
What axis does it show in the error?
Electronics Forum | Fri May 15 18:12:30 EDT 2015 | raynewing
I have 2x machines which display this error code. Any help would be greatly appreciated.
Electronics Forum | Tue Feb 09 09:18:13 EST 2010 | davemacnemo
Machine installer gave me some tips and a run through the software. Everything worked just fine. First solo attempt to run product that we started with gives L305 SoftLimitOver... error after picking first components and passing over camera. Additio
Electronics Forum | Wed May 02 09:14:08 EDT 2007 | stefi
Hi, We have a very annoying problem with a Philips Orion 2 SMT machine. It displays the error message "Second Limit Over" a few times per shift and it's impossible to make the machine work again unless it is turned off from the mains. It stops in th
Electronics Forum | Mon Apr 27 11:29:06 EDT 2015 | chris_jayconsystems_com
When I do the adjust to make sure the vision and tolerance is working it works perfectly. But if the machine runs a board I am riddled with this. I have checked the vacuum levels on all the heads and they are within where they are supposed to be for
Electronics Forum | Mon Feb 20 14:56:22 EST 2012 | acsscott
Ok, so we figured out that if the LCS is connected, we don't get the error. So, the HDLC data buss gos out and back, or is terminated in the LCS. How to remove the LCS? We try to go into maintenance screen to change the machine configuration, and
Electronics Forum | Fri Jan 21 00:11:50 EST 2011 | jeffr
Yes you must select FixedTrayFeeder. You must select TEACHING not AUTOSET. The trap is... you must select a TEACHING UNIT prior to doing the teaching (CAMERA-HEAD1-HEAD2)are the choices. Press F8 to get this menu to appear. If the camera cannot reac
| 1 |
