Electronics Forum | Fri Jul 19 12:58:13 EDT 2013 | rway
The review time varies depending on the product. But it could take anywhere from 10s to over a minute depending. That doesn't leave much time left on this new line. What AOI are you using now and with what equipment?
Electronics Forum | Thu Aug 18 11:38:34 EDT 2011 | johndoe0222
I got this error message on the fuji IP3: " Servo limit over. Servo Z1 Axis +" I was wondering how to fix this error. Thanks.
Electronics Forum | Tue Jun 26 08:47:09 EDT 2007 | geb
Hi we have a Universal GSM 1 flex head machine. It keeps on bringing up an "Axis Head 1 Z velocity over speed error during move absolute command". Pushing the e-stop button and then start again will allow it to continue making the panel. It happens r
Electronics Forum | Tue Jun 28 13:23:56 EDT 2005 | Bob Gilbert
Matt, Try a cooler profile by simply speeding up the conveyor by 10%. The difference may be the temperature the pads are reaching between the HASL boards and the Au boards. Are they the same thickness?
Electronics Forum | Tue May 21 07:03:14 EDT 2002 | smtexpert
Hi, My Tenryu 5500 is showing "X OVERRUN" Error while performing Origin. Can anybody tell the probable reason. thankyou. Priyaranjan
Electronics Forum | Thu Jan 05 23:49:12 EST 2017 | anhsang38
Dear All I'm having proplem with a component(resister). it was over turned after feeding,Depending the reel component so the mounter will be error when picking. i have already check feeder, it is ok. I'm suspecting the reel component was been esd.
Electronics Forum | Sat Jan 22 01:56:54 EST 2000 | Hany
HI Tony: We have the same case last month & we tried to fold a little sheet of metal (stainless steel I guess)on the fingers edge & it has worked perfectly. Only one fault among more than 1000 Pcs & it was referred to a manual error. You can try it,
Electronics Forum | Wed Jan 25 13:29:14 EST 2017 | emeto
you can check several things here: 1.Is this original tape or it is tape and reel service? 2. Is the cover tape that sticky, to lift component a little bit(sometimes might get the hole component). 3. Hole too loose, allow it to move too much 4. Fee
Electronics Forum | Tue Aug 13 10:08:44 EDT 2002 | dougt
Tony, I'm in Ken's corner.....the speeds the manufacturers offer are pretty much meaningless when it comes down to your particular board. Brand X can say they will do 1,000,000 cph but when you put your board on the machine with multiple parts at di
Electronics Forum | Fri Oct 09 06:32:38 EDT 2009 | davef
Here's what is on that post referred to, not sure what you need more than ... "* Stencil material: metal or plastic, no difference in print, metal is easier to clean, no static problem, available * Stencil thickness: Chips 0.006", SOIC 0.010" [print
