Electronics Forum | Thu Jul 31 10:45:13 EDT 2008 | miroyu
thank you very much. In my case quadalign board is at rear right corner but it does not have cage just is fitted on vertical aluminum metal sheet plate.I will add ground wire to the board and aluminum plate from machine ground. I will post what is o
Electronics Forum | Tue Sep 14 07:44:16 EDT 2021 | bukas
hi James. does this happen with every head or just Z6? Does the head move vertically at all? What ANC holder is selected in setup "Hole position detail"? There should be 4 options for "ANC hole position version". If the machine is CP45FV NEO then ANC
Electronics Forum | Thu Nov 03 05:55:34 EDT 2016 | lachrymal
Hi, I am struggling to interpret correctly the following statement: "An aperture oriented with its long axis in the same direction as the blade stroke does not fill as well as an aperture oriented with its short axis to the blade stroke." If I a
Electronics Forum | Wed May 29 17:17:49 EDT 2002 | wilcoxito
As far as aperture dimensions go, I found a technical note written by Micron that recommends using "square apertures with sides equal in length to the diameter of the PCB pad. The corners of the square should also be slightly rounded, and the apertu
Electronics Forum | Mon Feb 04 17:47:20 EST 2019 | arbpkevin
When I power up the machine and it finishes booting into VIOS, I normally hit the ready button to power up the drives so I can perform the origin search. Instead of "latching on" the contactors pull in, and then quickly release. If you hold down th
Electronics Forum | Thu Aug 26 13:20:56 EDT 2004 | pjc
Machine design plays a major factor in actual placement rate vs. the published tact time max speed. For example, random access horizontal turret head machines can vary greatly depending on nr. of different components and size ranges, while the dual g
1 |