Electronics Forum | Tue Oct 24 09:35:33 EDT 2006 | jax
The need to Pre-Bake depends on multiple variables: 1. Packaging from the vendor (dry packs, vacuum sealed, etc...) 2. Storage at your facility (temp, humidity, etc...) 3. Moisture absortion rate of Laminate (FR406BC is one of the highest) Other rea
Electronics Forum | Thu May 29 08:17:22 EDT 2014 | emeto
Edri, if the profile is good for this part and everything else on the board looks fine, I would focus all my attention to the part. How is it packaged? How is it handled? Moisture sensitive - prebake if needed.If nothing helps, try another batch or
Electronics Forum | Fri Feb 01 15:09:43 EST 2008 | chef
Don't do it.!!!! Are you nucking futs? Why is pre-bake required? Are you producing in high humidity? Is the package of the device poroues enough to suck in moisture? Think, consider you will not get an even "bake", the outside of the reel will get
Electronics Forum | Wed Oct 25 12:24:02 EDT 2000 | Philip
Hi Chris! I hope this will help you! The CBGA uses an array of high melting point solder spheres(Sn10/Pb90) to connect its ceramic chip carrier to an epoxy glass (FR4) PCB using eutectic (Sn63/Pb37) solder joints at both ceramic and card inter
Electronics Forum | Wed Dec 22 19:09:17 EST 2004 | rohman23
Very strange...I just logged into the internet to come post this very question for all the lurking experts. We have a 16 layer rigid-flex that we have never baked. Our board vendor is expressing concern that we do not perform a pre-bake before assy
Electronics Forum | Thu Oct 26 13:26:53 EDT 2000 | ptvianc
Hello: 1. Yes, it is necessary to reball a PBGA after removal from the board. Once the part has been removed, the quantity of solder on the balls is out of control. This condition will not only result in an unacceptable variation in solder quantity
Electronics Forum | Sat Jan 08 08:50:35 EST 2005 | davef
Normally, you should not have to bake boards that are properly packaged and stored. Since you are seeing problems, baking makes sense. Consider 125C for 4 to 6 hours. Additionally, look here for more, while waiting for others: http://www.smtnet.
Electronics Forum | Wed Oct 24 02:09:34 EDT 2018 | simondsr
Hi everyone, I am new to this SMT. I have just graduated my study, have zero experience in SMT industry as I studied Automotive before. Ok lets proceed to the main objetive, I have a question regarding package rebake. From what I have learned, the
Electronics Forum | Fri Nov 02 19:34:19 EDT 2018 | sarason
I am assuming that your application is Automotive. The logic here is that the product has got to at least run for 8 years or more. The prebake removes any moisture that may creep into the product during the wait time. A little moisture combined with
Electronics Forum | Wed Apr 05 08:51:25 EDT 2000 | Wolfgang Busko
Emmanuel: Popcorn effect is mostly caused by entrapped moisture in the components package material. Plastic ICs are known for absorbing and storing moisture when exposed to normal factory conditions. They should be stored in an moisture reduced envir