Electronics Forum | Wed Jul 01 12:26:52 EDT 2009 | ewchong
can anyone suggest possible causes or further analysis for the lifted pads in attached picture. thanks.
Electronics Forum | Tue Jul 07 08:42:49 EDT 2009 | ewchong
kpm, you are probably right. under magnification those two pads show some exposed copper which means that they were contaminated or had insufficient solder paste before reflow.
Electronics Forum | Thu Jul 02 13:10:22 EDT 2009 | kpm135
On first glance it looks like those particular pads were not attached to any traces. If I had to guess I would say that your rework profile got hot enough to melt away the glue holding the pads to the board and they came away with your part when you
Electronics Forum | Tue Jul 07 05:55:34 EDT 2009 | kpm135
I agree with your assessment of the two pins with irregular solder. The head-in-pillow or broken joint are both probable events for your defect. At this point in the process it will probably be difficult to pinpoint the exact cause. If it was a broke
Electronics Forum | Thu Jul 02 16:01:57 EDT 2009 | ewchong
thanks kpm. agree the cause of those pads lifting. all of them were no connects so they cannot be the cause of the electrical failure. when the bga was removed, all the solder balls on the pcb turned into conical shape due to the separation, except
Electronics Forum | Wed Oct 18 07:51:14 EDT 2006 | davef
Look here: http://www.circuittechctr.com/ As a low cost approach, use copper foil purchased from a stained glass window hobbyist shop. Cut foil pieces to size with a sharp knife. Epoxy the pieces in place of the damaged pads. Tin and then solder th
Electronics Forum | Tue Oct 17 12:07:58 EDT 2006 | pms
ya don't need no stinkin pads. just run sum fine gauge insulated jumpah wires from da I.C. legs (da ones with da missin pads) to da traces or where-ever dem traces end up. dat should get er dun !!!!
Electronics Forum | Mon Oct 16 17:46:49 EDT 2006 | Dan
Recently I was given a bad Bios Link from Toshiba which fried my Bios and now my laptop boots to a black screen. I recently unsoldered and removed the existing Bios chip and have ordered anotherfor replacement. Unfortunately while removing, i damag
Electronics Forum | Thu Sep 30 11:30:46 EDT 2010 | babe7362000
Take a few parts from the reel and look close at > the parts to make sure the bottom surface of the > leads is below the bottom surface of the body. Yes I did that and they are below the body. I found the problem I think. The solder mask is abo
Electronics Forum | Wed Sep 29 08:26:03 EDT 2010 | babe7362000
We are Currently running a Board and it seems that the SOT-223's on the bottom side have flux and water trapped under the part. Nothing has changed in our process and this is the only board that it is happening on. We are using Kester R562 water wa
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
