Electronics Forum | Thu Apr 29 22:50:41 EDT 1999 | Kelly Morris
Tombstoning 0805s w/palladium/platinum/silver terminations We are experiencing tombstoning problems on 0805 packages that have paladium/platinum/silver terminations. It comes & goes...... I�ve checked the reflow profile, and paste deposition and a
Electronics Forum | Mon Mar 30 08:11:22 EST 1998 | Derek Drabenstadt
Does anyone have any experience with fired-silver/platinum/palladium lead terminations soldering. I have had issues on nickel over gold plated boards but not with HASL'd boards with tin/lead pads. Is this the norm?
Electronics Forum | Mon May 03 09:42:45 EDT 1999 | Mike McMonagle
| Tombstoning 0805s w/palladium/platinum/silver terminations | | We are experiencing tombstoning problems on 0805 packages that have paladium/platinum/silver terminations. It comes & goes...... | | I�ve checked the reflow profile, and paste deposi
Electronics Forum | Sun May 02 18:52:36 EDT 1999 | JohnW
| Tombstoning 0805s w/palladium/platinum/silver terminations | | We are experiencing tombstoning problems on 0805 packages that have paladium/platinum/silver terminations. It comes & goes...... | | I�ve checked the reflow profile, and paste deposi
Electronics Forum | Wed Apr 01 02:19:10 EST 1998 | Eldon Sanders
Yes, norm it is. Look back to February 98 discussion on this issue.
Electronics Forum | Thu Apr 02 08:26:36 EST 1998 | Steve Gregory
| Yes, norm it is. Look back to February 98 :discussion on this issue. Norm, That discussion does deal with palladium coated leads, but when I read your statement about silver/palladium fired terminations, I'm assuming that you're referring to
Electronics Forum | Thu Feb 24 11:11:25 EST 2000 | Russ
I have seen this before, our problem was palladium termination of this component. We could not change suppliers so we use a "reverse homeplate" stencil design to put the majority of paste directly underneath the solder terminations of the component
Electronics Forum | Thu Feb 24 11:11:25 EST 2000 | Russ
I have seen this before, our problem was palladium termination of this component. We could not change suppliers so we use a "reverse homeplate" stencil design to put the majority of paste directly underneath the solder terminations of the component
Electronics Forum | Wed Apr 18 08:14:20 EDT 2007 | davef
Silver palladium termination * AgPd-terminated capacitors are designed for conductive adhesion. Reflow or wave soldering is not recommended. [EPCOS Multilayer ceramic capacitors, Soldering directions, October 2006] * CONDUCTIVE EPOXY BONDING. Epoxy c
Electronics Forum | Thu Jan 25 17:14:44 EST 2007 | slthomas
Good luck with that. ;) More likely you'll have to adjust your profiles. In our case with the palladium terminations we had to touch them up. There were other parts on the board that couldn't take more than 5 seconds at ~235 C� (don't remember for s
