Electronics Forum | Mon Mar 05 15:56:21 EST 2007 | jasont
NM-2858 is European style M size MV2F. NM-2859 is European style XL size MV2F. MV2F is manufactured rated at 0.1sec per placement however, I have only seen them acheive around 20-25,000 cph I have x2 MV2F-XL "Q" in stock (NM-2559MB) w/feeders. IF
Electronics Forum | Thu Oct 22 15:25:05 EDT 2020 | gabriel1blue
Thank you for your help. I did purchase one of those emulators but didn't work for some reason. Is there maybe a different setting on the jumpers? I will try again with the software you recommend and hopefully that does the trick. Gabriel
Electronics Forum | Thu Oct 22 22:08:35 EDT 2020 | gabriel1blue
The one difference is that the one from my machine has a 26 flex cable and gets the 5 volts from it as well, not an external source.
Electronics Forum | Fri Oct 23 05:15:47 EDT 2020 | gabriel1blue
My floppy drive is different. https://youtu.be/egS7fn3RweM This looks like something I need to try.
Electronics Forum | Fri Sep 08 13:51:19 EDT 2023 | carl_p
It's been some time since I used these machines. Are the sensors/arms ok at the top of the turret, their like arms that can move 90deg out....
Electronics Forum | Thu Oct 22 21:20:41 EDT 2020 | compit
I have installed these https://pl.aliexpress.com/item/1586956574.html?spm=a2g0s.9042311.0.0.64075c0fte25Rn in Assembleon Topaz-X (Yamaha YV100X) and Emerald-X machines and they work fine.
Electronics Forum | Thu Oct 22 22:13:20 EDT 2020 | gabriel1blue
I got new belts for the original floppy drives and installed them but the machine was reset to Japanese and after changing it back to English the drives are not running or powering up even though we can measure that the 5 volts are coming into it. I
Electronics Forum | Thu Oct 22 22:16:32 EDT 2020 | kumarb
The flat ribbon cable for the floppy drive is keyed and respectively, the RED STRIPE denotes pin # 1 on the Floppy Drive Connector. Do check that that is correct. As a simple test, remove the floppy drive and power up without the drive connected. D
Electronics Forum | Fri Oct 23 05:02:34 EDT 2020 | gabriel1blue
I change the settings to match another machine we have and that actually got the original drives working after replacing the belt. I ordered an adapter that will connect to the 26 pin flat cable and adapt to a 34 pin connector and pull the power from
Electronics Forum | Sat Aug 22 00:23:10 EDT 1998 | Arul Vanan
We are using PCBs of CEM3 Material with bare copper fiducials. The whole board is of bare copper with a lacquer coating (Coats brother S2974). The fiducials are of 1 mm diameter bare copper. we use Panasert MV2F as well as Fuji CP4-3. In both the m
