Electronics Forum | Wed Oct 27 10:22:15 EDT 1999 | a.blair
Fuji is usually the cheapest you will find. I think around $750 for them to repair it. the last time I checked they have an exclusive patent on their PCB backplane design so there would not be any real way to bench test it. they also have rights to t
Electronics Forum | Sat Nov 26 02:58:37 EST 2005 | sumxp
It could be the servo pack. We shut down the machine sometimes back and lastly sold it. The servo pack doesn't last long. Anyway,good luck to you.
Electronics Forum | Tue Feb 11 15:31:10 EST 2020 | sumote
We have not used out tray handler in several years, and when I had a need arise the thing now throws a Servo Error "MTU1 ALARM [11081010]. There are 4 servo packs in the cabinet. When I try to initialize/zero out the machine the 2nd and 4th servo pa
Electronics Forum | Thu Nov 04 06:46:19 EDT 2010 | adriana
We find the problem on Servo Pack for F theta axis .The component QM20TD-H Mediu power Switching is damaged! Many thanks!
Electronics Forum | Mon Mar 18 07:32:18 EDT 2013 | stephendo
It's been a long time but one thing I remember from those machines that about 50% of the time the error codes were a wild goose chase. At this point forget what the error code says. Can you move the head? Have you checked the servo cards? Is there
Electronics Forum | Mon Mar 18 09:19:48 EDT 2013 | marcelorotofrance
I can move the axes XYUV just in short steps through the "MANUAL NC" function. The axis encoders seem to work; the readings of position follow the axis movements. However the actual position of the head has nothing to do with the readings at the disp
Electronics Forum | Wed Dec 03 23:59:31 EST 2003 | masr
Basically the problem detail is, can't read the encoder reader from the motor, I swap the servo pack, the controler cards from the pc, the output cards from the plc, the motor and still have the problem!
Electronics Forum | Mon Oct 10 15:24:15 EDT 2005 | zl3vlf
Hello to all! Our Fuji FIP-3 placement machine has come up with a servo alarm (X2-axis) whenever we try to run the machine. The manuals don't go into a lot of detail as to the cause of this problem, but there is plenty of information on what the X2
Electronics Forum | Wed Oct 25 11:25:12 EDT 2017 | paddyronan
Hi all, I have a recent issue with an IP3 machine. The machine cycles through normal power up routine. Then the video monitor and VME card shit themselves down and after a couple of minutes the CPU board powers down. However this is intermittent. Wh
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
| 1 |
.gif)
winsouce.jpg)
